User Manual

BSS C ONFIGURATION AND U SER G UIDE
© VNL
®
2010-2011, All rights reserved Commercial in Confidence Page 101
6.5.1 Adding BTS
A trunkport with usage type Abis should be enabled and in
active state to add a BTS. The Trunk Port ID field of
Configuration - Add Row dialog box automatically populates.
Therefore, if no trunkport is configured then you cannot add
BTS. Refer “Configuring Trunkport
” to know how to enable
and activate a trunkport.
A BSS can have one or more BTS. An ABIS interface is
implemented between the BSC and each BTS.
Follow these steps to add BTS:
1. Open the BSS node in the modify mode.
2. Right-click BSS :<IP address> and click Add Element.
The Add Element dialog box appears.
3. Select ME type as BTS from the ME Type drop-down list.
The Configuration – Add Row dialog box appears.
The given below table describes the fields of the BTS
Configuration – Add Row dialog box.
Table 25: BTS Fields
Name Description Values
BTS ID Indicates the BTS id. 1 to
4294967294
Number of
Trx
Indicates the number of TRXs that can be
added for the BTS.
0 to 2
Trunk ID Indicates the trunk identifier of the Abis
Trunk to which this BTS is supposed to be
connected. 0 to 39 indicate external trunks
0 to 39, 51 to
58