User Manual

BSS C ONFIGURATION AND U SER G UIDE

Page 124 Commercial in Confidence © VNL

7.3.3.5 Deleting FRLink/NSVC

You can delete FRLink or NSVC in a BSS node. Here, as an

example, the deletion of NSVC is shown.

Follow the below steps to delete NSVC:

1. Open the BSS node in the modify mode.

2. Expand StackConfig, expand GB Interface, expand FR,

expand NSVC, and click NSVC : <IP address>.

3. Click Delete.

Alternatively, right-click NSVC: <IP address> and click

Delete.

LNote: You can delete NSVC, only if its administrative

state is locked.

7.3.4 Configuring IP

Internet protocol (IP) is the most popular communication

protocol used for transmitting packets from the source to the

destination based on their addresses.

This section explains the procedure of adding, modifying,

and deleting local end point (LEP) and remote end point

(REP) in a BSS node.

LNote: To add, modify, or delete LEP/REP, the

administrative state of BSC should be locked.

7.3.4.1 Adding LEP

You can add only one LEP. Follow the below steps to add

LEP:

1. Open the BSS node in the modify mode.