User Manual

BSS C ONFIGURATION AND U SER G UIDE

Page 136 Commercial in Confidence © VNL

You can select the cells to which you want to send the

message. When you provide the LAC information, the Select

Cell (s) dialog box appears.

4. Select the cells to which you want to send the message.

Click OK to close the Select Cells(s) dialog box.

In addition, you can select the Select All Cells checkbox to

send message to all the cells of the selected LAC.

5. Click Send to send the message.

The confirmation for the successful sending of the

message appears.

8.3.1 Message Broadcasting Report

You can check the status of the message that you have

broadcasted in the CB Report tab of the CBS window. The

messages that have been successfully sent and their

number of broadcast counter is over are not shown in this

tab. In addition, report contains information about

messages, which are not broadcasted due to failure on

node.

Messages that are being broadcasted and those with failed

status are shown in this tab. The broadcasting status can

change to failed if cell is disabled during broadcast of the

message. In addition, the status can change to broadcast

from failure if the broadcast timer has not expired.

You can stop the broadcasting of a message to a cell or

LAC by using this tab.

Follow the below steps to view and stop broadcasting a

message:

1. Open Cell Broadcast Service window.