User Manual

BSS C ONFIGURATION AND U SER G UIDE

• Disconnect: Used to disconnect a ME from a network.

• Shut Down Active: Used to shutdown a ME, which is in

active state. The standby card becomes active. This puts

the card in hot swap state (meant for maintenance

purpose) and you can jack-out the card. This is also

called as graceful shutdown of the processes.

• Shut Down Standby: Used to shutdown a ME, which is in

standby mode. This puts the card in hot swap state

(meant for maintenance purpose) and you can jack-out

the card. This is also called as graceful shutdown of the

processes.

• Block: Used to block a ME from accessing or using a

network.

2.3 BSS Configuration Workflow

The figure below depicts the workflow for configuring the

BSS node:

After assigning the BSS node to OMC, you should configure

trunkport so that BSC, BTS, and MSC can communicate

with each other.

You can configure stack, radio, and software after

configuring BSC.

In addition, you should follow the procedure given in the

following sections of this document to successfully configure

and manage the BSS node.