User Manual

BSS C ONFIGURATION AND U SER G UIDE
Page 38 Commercial in Confidence © VNL
®
2010-2011, All rights reserved
Name Description Values
sending the handover-required
message to MSC.
tWaitTrxBlock Indicates the maximum allowed time
after which TRX is forcefully blocked.
30 to1800
sec
4. In the Configuration – Add Row dialog box, provide the
values and click Ok.
This adds the BSC successfully in the selected BSS node.
4.2 Viewing BSC Details
You can view and modify the details (fields) of BSC, which
you have added. You can view the field either in
Configuration – View Node window or in Configuration –
Modify Node window. In the former, you can only view the
fields but in the latter, you can view and edit the fields.
Follow the below steps to view the configuration details of
the BSC node:
1. Open the BSS node in the view mode.
2. Click BSC and click BSC: <IP address> in the left-pane.
The right-pane displays the BSS CS and BSS PS tabs as
shown below:
Refer to “Table 4” for details about the fields in the BSS CS
tab.
The BSS PS tab contains configurable packet switch (PS)
parameters, which are applicable on BSS. To configure
these parameters, refer to “Modifying BSC Details”.
The following table explains the various fields in the BSS PS
tab: