User Manual

BSS C ONFIGURATION AND U SER G UIDE
© VNL
®
2010-2011, All rights reserved Commercial in Confidence Page 41
6. Click Ok.
After modifying the fields, you should unlock the BSC to
make the BSC operational.
If the administrative state of BSC is unlocked then you
cannot modify any fields of the BSC. In the unlocked state,
the BSC is in operational state, which implies that BSC is
communicating with BTS.
4.5 Configuring Timers
Timers are preconfigured during factory setup. However,
you can also configure the timers. Locking of any object is
not required for modifying the timer values. However, in
case of modification, you should provide values in all the
fields of a timer. These are the timers:
• Base station subsystem application part (BSSAP) timers
• Message transfer part (MTP3) timers
• PDC timers
• Signaling connection control part (SCCP) timers
Follow the below steps to modify values/fields of any timer
listed above:
1. Open the BSS node in the modify mode.
2. Click the TimersConfig ME.
3. In the left-pane, click any timer that you want to modify.
4. In the right-pane, edit the fields of the selected timer.
5. Click Modify to modify the values.
The Confirmation message box appears.
6. Click Ok.