Owner's manual

SECTIONTSM 630.4 ISSUE D PAGE8 OF 10
OPERATION
1. Press and hold the Infinity Key for two seconds to bring up
theHomePage.
2. UsetheUpandDownArrowKeystoadjustthesetpoint
temperatureifnecessary.ThelowerdisplayoftheHome
Page shows the set point temperature. The set point
temperature needs to be slightly higher than the melting
point and significantly lower than the flash point or boiling
point of the liquid being pumped.
WARNING !
Depending on the set point temperature at
startup, the controller may deliver power to
the heat cartridges and cause them to heat as
soon as the controller is turned on.
WARNING !
Setting the set point temperature higher than
necessary will not make the pump heat any
faster and will shorten the life of the heat
cartridges.
3. Tomakesurethattheliquidwithinthepumpismeltedand
toavoiddamagetothepump,donotstartthepumpuntil
thesetpointtemperaturehasbeenreached.Depending
onyoursetup,theremaybeareadylighttoindicatewhen
thesetpointhasbeenreached.OntheHomePage,the
upper display shows the process temperature, and the
lower display shows the set point temperature.
!
!
KEY LAYOUT AND FUNCTIONS
Upper Display
IntheHomePage,displaysthe
processvalue,otherwisedisplays
the value of the parameter in the
lower display.
Temperature Units
Indicates whether the
temperature is displayed in
FahrenheitorCelsius.
Zone Display
Indicates the
controllerzone.
Percentage Units
Lights when the controller
is displaying values as a
percentage.
EZ Key
NotUsed
Output Activity
NumberLEDsindicateactivity
ofoutputs.Aflashinglight
indicates output activity.
#2indicateswhenpower
applied to heaters.
Lower Display
Indicates the set point
or output power value
duringoperation,orthe
parameter whose value
appears in the upper
display.
Up and Down Arrow Keys
IntheHomePage,adjuststhe
set point in the lower display.
Inotherpages,changesthe
upper display to a higher or
lowervalue,orchangesthe
parameter selection.
Infinity Key
Presstobackuponelevel,orpressandholdfortwo
secondstoreturntotheHomePage.FromtheHome
Page,youcanclearalarmsanderrorsifclearable.
Advance Key
Advancesthroughparameterprompts.
NOTE:
This controller has been pre-
programmed by Viking Pump
to lockout many functions
to simplify installation and
operation for customer specified
electric heat applications.
If advanced functionality is
required, the user should
source their own controller from
a qualified heat control vendor.