Installation Guide

7
Installation
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for fi nal positioning of your refrigerator:
• All four corners of the cabinet must rest fi rmly on the
fl oor.
• The sides should tilt
¼ inch (6 mm) from front to back
(to ensure that doors close and seal properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1. Slightly open freezer drawer if the toe grill is installed. Lift
the toe grille and gently pull forward.
2. Make initial cabinet adjustments by using the front roller height
adjusting screws. Use a 3/8 inch socket wrench to turn the
adjustment screws (1 per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw counterclockwise.
3. Ensure both doors are bind-free with their seals touching
the cabinet on all four sides and that cabinet is stable.
4. After unit is leveled, lower anti-tip leg using a 3/8 inch
socket wrench until it fi rmly contacts the fl oor.
Raise
Lower
Anti-tip
Leg
Door
Door
5. Install the toe grill by fi tting into place.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
(2) Retaining Clips
To make fi nal door height adjustments:
1. Open freezer drawer to make lower hinge visible.
2. Insert 6mm Allen wrench into the shaft of the lower hinge.
3. Adjust the height by turning clockwise or
counterclockwise. Turning clockwise will lower the door.
Turning counterclockwise will raise the door. Default
setting is to the lowest height when you receive your
appliance
Adjusting Flipper Mullion Screw
To adjust the fl ipper mullion:
1. Loosen the screw located on the fl ipper mullion hinge.
2. Adjust fl ipper mullion height. For proper connection with
the fl ipper mullion guide, there should be a separation
about the thickness of a coin (0.060 inches, or 1.5 mm)
between the guide and fl ipper mullion.
3. Re-tighten screw.
Adjusting Flipper Mullion Height
Raise