Use & Care Guide Guia de Uso y Cuidado Guide d’utilisation et d’entretien 3 Series French Door Bottom Freezer/Refrigerator Refrigerador con congelador inferior de puerta doble Réfrigérateur à portes françaises/Congélateur en bas
Finding Information Please read and save this guide Table of contents We hope you will enjoy and appreciate the care and attention we have put into every detail of your new, state-ofthe-art refrigerator. Finding Information .............................................................. 2 Your appliance is designed to offer years of reliable service. This Use and Care Guide will provide you with the information you need to become familiar with your refrigerator’s care and operation. Feature Overview ...
Safety Important safety instructions Safety Precautions Child Safety Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Danger, Warning, or Caution based on the risk type. Packing Materials: • Packing cartons covered with rugs, bedspreads, plastic sheets, or stretch wrap may become airtight chambers and can quickly cause suffocation.
Safety Electrical information IMPORTANT WARNING CFC/HCFC DISPOSAL Your old refrigerator may have a cooling system that used CFCs or HCFCs (chlorofluorocarbons or hydrochlorofluorocarbons). CFCs and HCFCs are believed to harm stratospheric ozone if released to the atmosphere. Other refrigerants may also cause harm to the environment if released to the atmosphere. You must follow these guidelines to ensure that your refrigerator’s safety mechanisms are operating correctly.
Feature Overview Understanding features and terms Your refrigerator is designed for optimal convenience and storage flexibility. The illustration below is provided to assist you with familiarizing yourself with product features and terminology. NOTE Features may vary according to model. Model is shown without freezer drawer cover.
Installation Required Tools You will need the following tools: This Use & Care Guide provides general installation and operating instructions for your model. We recommend using a service or kitchen contracting professional to install your refrigerator. Use the refrigerator only as instructed in this Use & Care Guide.
Installation CAUTION Shoulder Screws Do Not loosen or remove these (3) hex head screws. Clip DO NOT Loosen or Remove These 3 Hex Screws Toe Grille Shoulder Screw Figure 2: Lift the toe grille and gently pull forward. 3 You can raise or lower each door. Use a ⅜ inch socket wrench to turn the adjustment screws (one per side). To raise: turn adjustment screw clockwise. To lower: turn adjustment screw counterclockwise.
Installation To adjust the door stop: 5 Re-tighten screw. Door stop is adjustable between 85 to 145 degrees. NOTE View shown is looking up at the bottom of the refrigerator door. Re-tighten Screw 6 Ensure door stops in desired location before resuming normal use. To level the doors using the adjustable lower hinge (select models): Adjustable Door Stop 1 Remove all food items from door bins on door being 1 Open door to provide access to screw. adjusted. 2 Loosen screw. 2 Open doors to 90 degrees.
Installation 3 Lift the door while adjusting the washer. To raise the To adjust the flipper mullion: door, rotate washer clockwise (when viewed from the bottom). To lower door, rotate washer counterclockwise (when viewed from the bottom). Do 1 Loosen the screw located on the flipper mullion hinge. or Lower Door Hinge Washer Raise Door Raising/Lowering Door Adjusting Flipper Mullion Screw 2 Adjust flipper mullion height.
Removing the Doors 2 Disconnect the harness by grasping both sides of the Getting through narrow spaces connector firmly, depress the latch, and pull apart. Remove the two screws from the top hinge. Lift the door off of the bottom hinge and set it aside. If your refrigerator will not fit through an entrance area, before installing the door handles, you can remove the doors. Check first by measuring the entrance.
Removing the Doors Removal and Installation of lower Freezer Drawer Installing the Door Handles 1 There are 6 handle studs on the refrigerator. CAUTION Drawer is heavy. Use caution when lifting Removing Freezer Drawer: 1 Remove (4) hex head drawer screws. 2 Lift up drawer to remove. 2 Slide handle endcaps over door stud. DO NOT Remove Other Screws Remove Hex Head Drawer Screw 3 Tighten the set screw. There are 2 set screws per handle assembly.
Connecting the Water Supply To Connect Water Supply Line To Ice Maker Inlet Valve WARNING 1. Disconnect refrigerator from electric power source. 2. Place end of water supply line into sink or bucket. Turn ON water supply and flush supply line until water is clear. Turn OFF water supply at shutoff valve. 3. Remove plastic cap from water valve inlet and discard cap. 4. If you use copper tubing - Slide brass compression nut, then ferrule (sleeve) onto water supply line.
Controls An indicator light will be illuminated above most active features. Touch the icon to activate the options below. fast freeze Activates a faster rate for freezing food. fast ice Increases the production of ice. energy saver Keep this switch set on energy saver (light on) for lowest energy usage. If moisture appears on the cabinet between the doors, pressing this button will turn the light off and enable an electric heater used to reduce moisture on the cabinet between the doors.
TruTouch Controls Sabbath Mode NOTE The Sabbath Mode is a feature that disables portions of the refrigerator and its controls in accordance with observance of the weekly Sabbath and religious holidays within the Orthodox Jewish community. If the Temperature Adjustable Cold Zone Drawer is not turned off prior to putting the unit into Sabbath Mode, it will continue to adjust itself to maintain the set point even if the display does not illuminate to show that it is still on.
Automatic Ice Maker • The following sounds are normal when the ice maker is operating: Ice maker operation & care After the refrigerator is installed properly, the ice maker can produce ice within 24 hours. It can completely fill an ice bin in about three days. - Motor running - Ice dropping into ice bin - Water valve opening or closing When using the ice maker for the first time and in order for the ice maker to work properly, it is necessary to clear air from water filter tubing.
Storage Features Shelf features Drawers Your refrigerator includes a variety of storage drawers. These drawers are located in fixed positions at the bottom of the fresh food compartment. CAUTION To avoid injury from breakage, handle tempered glass shelves carefully. Crispers Crisper drawers are designed for storing fruits, vegetables, and other fresh produce. NOTE Features may vary according to model. Your refrigerator includes glass shelves that are designed to catch and hold accidental spills.
Storage Features To remove the Crisper Drawer for cleaning: Special items rack (select models) The innovative design of the special items rack allows you to store four bottles of wine or soft drink bottles. 1 Pull the drawer out until it stops. 2 Lift the front slightly and remove the drawer.
Storage Features To change the position of an adjustable door bin: IMPORTANT 1 Before adjusting a bin, remove all food. DO NOT clean the display area of the Custom TempTM Drawer with abrasive or caustic cleaners. Wipe clean with a moist sponge. 2 Grip the bin firmly with both hands and lift it upward. 3 Remove the bin. 4 Place the bin just above desired position. 5 Lower the bin onto supports until locked in place.
Storage Features To reinstall lower basket, insert basket into retainer clips. Freezer Features Tilt Wire Shelf Stabilizer Bar The freezer tilt wire shelf (located on the inside of the freezer drawer) is not designed to be removed. Dividers Removal Lift up on the front of the upper divider and pull out. Basket Retainer Clips Two Freezer Baskets To Remove Upper Basket 1 Remove all items from basket. 2 Remove basket by pulling basket out to its full extension and lift out.
Storing Food and Saving Energy Ideas for storing foods Ideas for saving energy Fresh food storage Installation • Keep the fresh food compartment between 34°F and 40°F with an optimum temperature of 37°F. • Locate the refrigerator in the coolest part of the room, out of direct sunlight, and away from heating ducts or registers. • Avoid overcrowding the refrigerator shelves, which reduces air circulation and causes uneven cooling.
Normal Operating Sounds Understanding the sounds you may hear Your new, high-efficiency refrigerator may introduce unfamiliar sounds. These sounds normally indicate your refrigerator is operating correctly. Some surfaces on floors, walls, and kitchen cabinets may make these sounds more noticeable. NOTE Energy efficient foam in your refrigerator is not a sound insulator.
Changing The Water and Air Filters Your refrigerator is equipped with separate water and air filtering systems. The water filter system filters all the water used to produce ice. The air filter removes odors and impurities from the refrigerator compartment. 1 Push the filter release button above the cartridge to disconnect it. 2 Slide the old water filter cartridge straight out of the housing and discard it. NOTE The control panel includes controls to monitor the status of your water and air filters.
Changing The Water and Air Filters 4 Push firmly until the cartridge snaps into place (you should hear two clicks). When fully engaged, Air filter The air filter is located under the utility bin. the front of the filter cartridge should be flush with the filter release button. Replacing your TruAir air filter To ensure optimal filtering of refrigerator odors, you should change the air filter every six months (the filter status light on the Touch Panel prompts you to replace the filter after six months).
Care and Cleaning Protecting your investment Keeping your refrigerator clean maintains its appearance and prevents odor build-up. Wipe up any spills immediately and clean the freezer and fresh food compartments at least twice a year. NOTE Do not use abrasive cleaners such as window sprays, scouring cleansers, flammable fluids, cleaning waxes, concentrated detergents, bleaches, or cleansers containing petroleum products on plastic parts, interior doors, gaskets, or cabinet liners.
Care and Cleaning Care and cleaning tips Part Cleaning Agents Tips and Precautions Interior & Door Liners Soap and water Baking soda and water Soap and water Soap and water Use two tablespoons of baking soda in one quart of warm water. Be sure to wring excess water out of sponge or cloth before cleaning around controls, light bulb or any electrical part.
Care and Cleaning Replacing LED Lights (select models) NOTE Both the freezer and fresh food compartments of your refrigerator include LED lights. Always use Viking Range parts for replacement. LED lights are in series so if one is bad or unplugged, several lights may not light up. To replace LED Lights: Ordering Replacement LED Lights 1 Unplug your refrigerator’s power cord. Order new LEDs by calling 888-845-4641, online at www. vikingrange.com in the US or brigade.
Solutions to Common Problems Before you call... If you experience a concern with your refrigerator or notice a product behavior or condition that you do not understand, you can usually avoid a call to your service representative by referring to this section for an answer. Beginning with the following table, this information includes concerns, potential causes, and common solutions. Automatic Ice Maker Problem Cause Ice maker is not making any ice. • Ice maker is turned off.
Solutions to Common Problems Opening/Closing Of Doors/Drawers Concern Potential Cause Common Solution Door(s) will not close. Refrigerator is not level. It rocks on the floor when moved slightly. Ensure floor is level and solid, and can adequately support the refrigerator. Contact a carpenter to correct a sagging or sloping floor. Check for ice or food items blocking drawer. An object has fallen from the baskets blocking the door from closing. Drawers are difficult to move.
Solutions to Common Problems Temperatures Are Too Warm Concern Potential Cause Common Solution Freezer/Refrigerator temperature is too warm. Doors are opened too frequently or too long. Warm air enters the refrigerator whenever the door is opened. Open the door less often. See Concern section, Opening/Closing of Doors/ Drawers. Door is slightly open. Freezer temperature is too warm. Refrigerator temperature is satisfactory. Freezer control is set too warm.
Service Information If service is required, call your dealer or authorized service agency. The name of the authorized service agency can be obtained from the dealer or distributor in your area. Have the following information readily available: • Model number • Serial number • Date purchased • Name of dealer from whom purchased Clearly describe the problem that you are having.
Warranty FREESTANDING FRENCH DOOR REFRIGERATOR/FREEZER WARRANTY ONE YEAR FULL WARRANTY Freestanding french door refrigerator/freezers and all of their component parts, except as detailed below*†, are warranted to be free from defective materials or workmanship in normal residential use for a period of one (1) year from the date of original retail purchase. Viking Range, LLC, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the warranty period.
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com in the US or brigade.ca in Canada Pour toute information concernant le produit, appelez 1-888-845-4641 ou visitez le site Web à www.brigade.ca Para obtener información sobre los productos, llame al teléfono 1-888-(845-4641) o visite el sitio web en vikingrange.
