Use and Care

39
USA
• Machine is unloaded right after the program is over. >>> Do not unload your
machine right after washing process is completed. Slightly open the door and
wait for steam to escape inside of unit. Unload the dishes after the pieces
cool down to a touchable level. Start unloading process from the lower basket
to prevent dropping of water from items in upper basket onto the items in
lower basket.
• Selected program is unsuitable. >>> Since rinsing temperature is low at
program with short duration, drying performance will also be low. Select
program with longer duration for a better drying performance.
• Surface quality of the kitchen utensils is deteriorated. >>> Desired washing
performance can not be obtained for kitchen utensils with deteriorated
surfaces and it is not suitable to use such utensils in terms of hygiene
as well. Also, water can not flow easily on deteriorated surfaces. It is not
recommended to wash such kitchen utensils in dishwasher.
C
It is normal that drying complaints can be experienced with non-
stick kitchen utensils. It is associated with the structure of non-stick.
Since the surface tensions of non-stick and water are different, water
droplets will remain as beads on the non-stick surface.
Stains remaining on dishes when cycle has completed.
• Selected program is unsuitable. >>> Select a program with a higher
temperature and cycle time.
• Surface quality of the kitchen utensils is deteriorated. >>> Tea and coffee
stains or other dye spots may not be cleaned in dishwasher when they have
penetrated in deteriorated surfaces. Desired washing performance can not be
obtained for kitchen utensils with deteriorated surfaces and it is not suitable
to use such utensils in terms of hygiene as well. It is not recommended to
wash such kitchen utensils in dishwasher.
• Detergent is stored under unsuitable conditions. >>> If you are using powder
detergent, do not store the detergent package in humid places. Keep it in
a closed container if possible. For ease of storing, we recommend tablet
detergents.
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid
if necessary. Increase the rinse aid setting if there is enough amount of rinse
aid in the machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the
hardness of the supply water appropriately and check the water hardness
setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling
hole while adding salt. Make sure that the salt reservoir lid is tightly closed
after finishing the filling process. Run the Rinse & Hold program to remove
the salt that spilled inside the machine. Since the salt granules that will
remain under the lid will dissolve during Rinse & Hold, causing the lid to
loosen, check the lid once again at the end of the program.