Specifications

Page 24
4.1.2 Gearbox Dismantling
(After Completing 4.1.1).
The following procedures assume that pump has been removed from the
baseplate and that the product seals have been removed (see section 4.3).
- Remove drain plug (5) and breather (21). Drain lubricant into suitable
container and retain if later inspection is required.
- Remove retaining screws (74), and remove the endplate (70) from the
gearbox (16) utilising the retaining screws (74) in the jacking points
provided, see fig 12. The endplate is located on dowels (60) and is sealed
by the o-ring (3), see fig 11.
- Remove the cups of the rear bearing (19, see fig 5.6) from the endplate
(70).
- Remove the bearing pre-load shims (73, see fig 5.6). The shims (73, see
fig 5.6) may be different for each assembly and therefore should be
kept in their respective positions.
- Remove rear lipseal (11, not shown).
Fig 11 Endplate Removal.