Specifications

Page 31
Fig 17 Aligning the mesh point.
- Remove the shaft assemblies from the gearbox (16).
- Using the holes provided drill and ream both gear (14) and shaft (9 and
10) to suit Ø6.0 mm dowel (80), as shown in fig 18. It is important to drill
and ream the hole so that the dowel is positioned equally between the
gears (14) and shafts (9 and 10).
Fig 18 Installing and positioning the timing dowel.
- Install the Ø6.0 mm dowel into the drilled and reamed hole; apply a
suitable adhesive to ensure that the dowel stays in place.
Drill & Ream to suit
Ø6.0 mm dowel.