Specifications

Page 38
4.3.5 RTP30 Standard Radial Lip Seal.
Fig 21 Standard Radial Lip Seal Cartridge.
Read the general procedures before proceeding, refer to section 4.3.1.
- Remove dome nuts (36), front cover (38), rotor retainers (35), rotors (41)
and front cover o-ring (39), see section 4.1.
- Remove the lip seal cartridge assembly from the rotor (41).
- The seals can now be accessed for inspection.
- The individual lip seals can now be removed and replaced (if required)
from the cartridge.
- If required, remove the seal sleeve (66) from the rotorcase by releasing
the retaining nut (12), when replacing the seal sleeve (66), alignment
between the seal sleeve and rotorcase must be achieved to prevent
rotation.
Note: Extreme care should be taken when carrying out these procedures
to ensure that the seal faces are not damaged.
- Assembly is the reverse of the above procedure, ensure that all faces are
clean and free from damage.
- To install the lip seals, press each seal into position and apply suitable
lubricant to the second & third seals.
WARNING
WARNING