Specifications

Page 8
2.0 Introduction.
2.1 General.
RTP
TM
rotary lobe pump is manufactured by Johnson Pump (UK) Ltd. a
subsidiary of Viking Pump Inc., Cedar Falls, USA, (a unit of the IDEX
Corporation) herein after referred to as ‘JPUK’.
This manual includes all the necessary information for RTP
TM
pumps and
should be read prior to beginning installation, operation, or maintenance.
Should you require any additional information regarding the RTP
TM
pumps
contact JPUK or their local authorised distributor (refer to section 2.2).
When asking for assistance please provide the pump model and serial
number. This information can be obtained from the pump nameplate, which is
located on the side of the pump gearbox cover, see fig 2. Should the
nameplate be unreadable or missing, the pump serial number is also stamped
on either side of the rotorcase, see fig 3.
If the system or product characteristics are to be changed from the original
application for which the pump was selected, Johnson Pump (UK) or their
authorised distributor should be consulted to ensure the pump is suitable for
the new application.
2.2 Johnson Pump (UK) Ltd. Distributors.
JPUK distributes its products internationally via a network of authorised
distributors. Throughout this manual where reference is made to JPUK,
service and assistance will also be provided by any JPUK authorised
distributor for RTP
TM
pumps.
2.3 Receipt and Storage.
Upon receipt of the pump, immediately examine it for any signs of visible
damage. If any damage is noted, contact JPUK or your JPUK distributor and
clearly mark upon the carriers paperwork that the goods have been received in
a damaged condition, with a brief description of damage.
If the pump is not required for immediate installation then it should be stored
in a clean, dry environment. It is recommended that storage temperature
should be between –10°C and 40°C (14°F and 105°F).