Use & Care 15”W.
CONGRATULATIONS Congratulations and welcome to the elite world of appliance ownership. We hope you will enjoy and appreciate the care and attention we have put into every detail of your new, state-of-the-art ice machine. Your appliance is designed to offer years of reliable service. This Use and Care Guide will provide you with the information you need to become familiar with your ice machine’s care and operation. Your complete satisfaction is our ultimate goal.
IMPORTANT – PLEASE READ AND FOLLOW • • • • • Before beginning, please read these instructions completely and carefully. DO NOT remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. Please observe all local and national codes and ordinances. Please ensure that this product is properly grounded. The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future reference.
INITIAL START UP 1. Turn on the water supply. 2. Switch on the electrical power. 3. Push and release the On/Off switch to start the machine. The Ice Making light next to the On/Off switch will glow Blue. 4. Water will begin to flow into the unit. When the reservoir is full, water will start to drain from the machine. After a few minutes the compressor, water pump and fan motor will begin to operate and the first ice making cycle will have begun. No adjustments are needed.
WATER QUALITY All water, including potable water supplied by municipalities, contains some impurities or minerals. Water absorbs impurities from the air as rain and/or as it flows through the ground. Some of the impurities are solid particles, these are known as suspended solids, and a fine particle filter will remove them. Other impurities are chemically bonded to the water molecules, and cannot be filtered out, these are called dissolved solids.
CARE AND CLEANING Condenser cleaning The condenser is like the radiator on a car, it has fins and tubes that can become clogged with dirt and lint. To 1. 2. 3. 4. clean: Remove the kickplate and front service panel. Locate the condenser surface. Vacuum the surface, removing all dust and lint. Return the kickplate and front service panel to their original positions. Fasten them to the cabinet using the original screws. Condenser surface CAUTION DO NOT dent the fins. Winterizing 1.
Removing scale from the ice making system 1. Scoop out all of the ice, either discard it or save it in an ice chest or cooler. 2. Press and HOLD the On/off button in for 3 seconds until the Blue light goes out. 3. Press and HOLD the both the Clean-Reset and On/Off buttons for 5 seconds. The Time to Clean light will blink on and off. 4. Pour 8 ounces of Ice Machine Scale Remover into the ice machine reservoir. Pour scale remover here 5. Operate the machine for about ½ hour. 6.
TROUBLESHOOTING GUIDE PROBLEM CORRECTION Ice cubes are incompletely formed • Clean the ice making system. Low capacity • Check for restricted drain or standing water in the bin. • Clean the air cooled condenser fins. No ice • Check On/Off switch. • Check electrical breaker. • If the “Check Water” light is flashing blue, check water supply. The control system checks for water every 20 minutes. When the water supply is restored, the machine will automatically restart ice making.
FGMI/FP
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit our web site at vikingrange.com in the US or brigade.