User`s guide

Instruction book Freesia 415, 425

1. Place an empty bobbin with the mark outwards on the bobbin spindle on the

front of the machine.

2. Place the large spool holder under the thread on the spool pin.

3. Bring the thread under the thread guide (a) and over thread guide (b), then

around thread guide (c) as illustrated.

4. From above wind a few turns of thread around the bobbin and into the

cutter.

5. Bring the bobbin spindle down. Press the foot control. When the bobbin

winding is finished, the bobbin will stop automatically. Remove the

bobbin, cut off the thread and bring the bobbin spindle up.

Bobbin winding with the machine threaded

Make sure that the presser foot is up and the needle is in the highest posi-

tion.

Note! Do not use a plastic presser foot when bobbin winding.

1. Place your empty bobbin with the small mark outwards on the bobbin spindle

on the front of the machine.

2. Pull the thread from the needle under the presser foot and to the right over the

thread guide (c).

3. Start from above and wind a few turns of thread around the bobbin. Cut off the

thread on the thread cutter (d).

4. Bring the bobbin spindle down. Press the foot control. When the bobbin

winding is finished, the bobbin will stop automatically. Remove the bobbin,

cut off the thread and bring the bobbin spindle up.

Note! We do not recommend winding clear nylon or other stretchy threads

through the needle. Instead see "Bobbin winding - vertical spool pin".

Bobbin winding - vertical spool pin