Use and Care Manual / Installation Instructions



Access reservoir (Fig. 1)

1. If present, remove the bottom grow tray

2. Slide out drawer to access the reservoir

 Fill reservoir

1. Make sure that the unit has been connected to the water and power

according to local codes

2. From the HOME screen, press SET UP, SET RESERVOIR, AUTO ON, FILL

3. Wait until the reservoir is full with water. Monitor the lling of the res-

ervoir to assure proper ll.

Fig. 1

Fig. 2

Fig. 5 Zone

irrigation nozzle

Irrigation pump

 Priming

1. Access the priming valve near the irrigation pump. It should be in the OPEN position and

water should be owing downwards into the reservoir

2. From the HOME screen, choose ZONE 2 (A). This will be the growing zone that is directly

above the pump. Press WATER NOW (B).

3. Open (1/4 clockwise turn) and wait for steady stream of water to come out of the priming

valve (Fig 3); once you have a steady stream of water, close the valve (Fig 4).

4. Water should now be owing steadily from the irrigation nozzle in the zone selected in

step 2 (Fig. 5). Press WATER NOW (B) to turn o the watering cycle for that zone. Leave

the priming valve in the CLOSED position.

Your pump is now primed.

Fig. 4

Priming valve in

CLOSED position

Fig. 3

Priming valve in

OPEN position

Priming valve

START-UP (continued)

PRIMING THE IRRIGATION PUMP