Use and Care Manual / Installation Instructions

SET UP THE DATE AND TIME

On the home screen, press the date/time in the upper right hand corner. This will take you to the TIME AND DATE SCREEN (A).

Using the UP and DOWN arrows, set the date and time.

Press DONE when you are nished.

The date and time are now set so you can accurately program and monitor the growing cycles.

GCV12

2 zones

Note: The cabinet must be plugged in or hard wired and plumbed by a professional technician. Follow these steps to set

up your cabinet for the rst time.

SELECT SEEDS FROM THE SEED LIST

The cabinet comes with pre-set cycles for growing a variety of plants. It can also be programmed to set up the zones for special

seeds or changing the lighting and watering cycles for each plant. On the HOME screen (B), select the zone for the seed you

would like to program: GCV12 (2 zones). On the zone screen (C), press CHANGE SEED and you will be taken to the FAVORITES

screen(D).

An alphabetical list of preprogrammed seeds will appear. Scroll through the list to nd the seed you want, using the NEXT but-

ton to get to each screen (there are 5 screens, with a few spaces left empty at the end for custom programming of new items).

NONE is the rst item and can be used for designating shelves that might not be needed during a particular growing cycle. A

list of the preprogrammed seeds appears on page 14. Press SELECT to choose your seed. Repeat for each of the zones you wish

to use.

SETTING UP YOUR GROWING CYCLES

C D

Continued on next page