Operation Manual

ENNO
17
SVFIDAPL
0478 192 9803 B - EN
If the ignition key is moved to this position
when the engine is running, the lights are
switched on and the engine continues to
run (operation with lights).
Ignition on / engine running:
If the ignition key is moved to this
position when the engine is
stopped, the ignition is switched
on without the engine starting.
Following start-up, the ignition key returns
automatically to this position and the
engine continues to run.
Start engine:
When all safety-relevant points
for starting are fulfilled and the
ignition key is turned to this
position, the engine starts.
Upon releasing the ignition key, it returns
automatically to the "engine running"
position.
8.2 Throttle lever with choke function
(MT 4097 SX, MT 4097 S, MT 4112 S)
Choke position:
Push throttle lever (1) fully forwards into
the choke position (note detent).
Setting the engine speed:
If throttle lever (1) is pushed downwards or
upwards, the engine speed changes and,
if the mowing deck is engaged, the speed
of the mowing blades is changed.
MAX position:
If the throttle lever (1) is moved forwards
towards the MAX marking, the engine
speed is increased.
MIN position:
If the throttle lever (1) is pushed back
towards the MIN marking, the engine
speed is reduced.
8.3 Throttle lever (MT 4112 SZ)
Setting the maximum engine
speed:
Note
When starting the machine when
the engine is cold, the throttle lever
must be set to the choke position
on models MT 4097 S,
MT 4097 SX, MT 4112 S.
Avoid damage to the machine.
It must always be ensured that the
throttle lever is not in the choke
position when the engine is
running. Immediately set the
throttle lever to the MAX position
after starting the engine.
Note
Only mow at the maximum engine
speed.
The throttle lever must be in the
MAX position.
Note
When starting the machine when
the engine is cold, the throttle lever
must be set to the MAX position on
model MT 4112 SZ. The choke
knob must also be operated.
Note
Only mow at the maximum engine
speed.
The throttle lever must be in the
MAX position.