Operation Manual
ENNO
25
SVFIDAPL
0478 192 9803 B - EN
Fit and screw on the tank cap (1) (note
direction of arrow). Then tighten the tank
cap (1) hand-tight.
● Wipe away any spilled fuel and allow it
to evaporate before starting the engine.
11.2 Starting the engine
The following points must be noted
before starting:
● Carefully read and observe the section
entitled "For your safety". (Ö 4.)
● Check the engine oil level. (Ö 13.9)
● Remove grass residues from the
mowing deck and engine compartment.
● Check the fuel.
● Before each use, check the braking
function. (Ö 11.5)
● Perform all personal settings (driver's
seat adjustment) on the machine.
Not when the engine is running!
● Never start the machine in the vicinity of
other persons, particularly children, or
animals.
Starting sequence
Start the machine in the following
sequence.
● Open fuel cock. (Ö 13.12)
● Before starting, press the brake pedal
to the stop and hold or engage the
parking brake. (Ö 8.10), (Ö 8.11)
● Check the mowing deck switch:
The mowing deck must be disengaged.
(Ö 8.5)
● Insert the ignition key in the ignition lock
and turn to the "ignition on/engine
running" position. (Ö 8.1)
● When the engine is cold:
MT 4097 S, MT 4097 SX, MT 4112 S:
Set throttle lever to the choke position.
(Ö 8.2)
MT 4112 SZ:
Set the throttle lever to the MAX
position and pull the choke knob.
When the engine is warm:
Set the throttle lever to the MAX
position. (Ö 8.3)
● Turn the ignition key to the “start
engine” position.
The engine starts. As soon as the
engine is running, release the ignition
key. This returns automatically to the
"ignition on/engine running" position.
● MT 4097 S, MT 4097 SX, MT 4112 S:
Return the throttle lever to the MAX
position when the engine is running.
Note detent! (Ö 8.2)
MT 4112 SZ:
Press in the choke knob. (Ö 8.4)
● The engine is running.
The foot can be removed from the
brake pedal.
11.3 Stopping the engine
Risk of injury:
Before starting, carefully read and
observe the section "For your
safety". (Ö 4.)
Only start the machine when the
user is sitting on the driver's seat.
When operating (e.g. mowing), the
throttle lever should always be in
the MAX position.
Avoid damage to the machine.
If the engine fails to start, it must be
noted that the engine can flood
following several starting attempts.
When attempting to start, the
ignition key should never be held in
the "start engine" position for more
than a maximum of 10 seconds.
Disengage the mowing deck before
stopping the engine. (Ö 8.5)