installation guide

3
3. Place the drawer adjacent to the wall or cabinet opening. Plug
the power supply cord into the electrical outlet.
4. Carefully guide the drawer into the prepared opening. Avoid
contact with the sides of the cutout opening and also pinching
the cord between the oven and the wall.
5. Slide the drawer all the way back until the mounting  anges
touch the cleats mounted in the cabinet opening.
6. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a 1/16” (1.57 mm) bit. See Figure 4.
7. Secure the drawer with the 4 screws supplied.
2. Install de ector
3
/4" (19.05 mm)
shelf
Side view
1
3
/4" (44.45 mm)
front face of shelf
Front face of cabinet
16
7
/8"
(428.62 mm)
ush opening
height
Move oven location
downward for extended
countertops for better
viewing angle.
Anti-Tip
block
Figure 2C
Shelf detail showing the deector vent installed.
Shelf detail showing the deector vent during installation.
Position deector vent and mark holes. Pre drill using a
1
/16" (1.57 mm) bit before mounting.
Figure 3A
Figure 3B
Figure 4
Mounting
ange