Cleaning Tips

RANGES / RANGETOPS / OVENS

CLEANING TIPS

GRATES/BURNER CAPS (sealed and open burners)

After cooking, always wipe down grates and burner caps with a damp sponge

and dry thoroughly. Normal cleaning can be done with hot, soapy water and/

or Soft Scrub cleanser (without bleach) with a blue Scotch-Brite pad. If stubborn

spots still occur, then use Easy-O Fume Free Max Oven Cleaner (see ﬁrst bullet

below).

Procedure for oven cleaner use: Take grates and burner caps o unit – move

outside and place on newspaper. Spray with Easy-O, let cleaner sit on spotted

areas for 1 – 2 hours. Clean o with hot, soapy water.

When cleaning grates and burner caps, make sure to thoroughly dry them,

especially underneath. If the bottom portion does not totally dry before setting

them back on the cooking surface, they may rust. You can also set the grates

and burner caps on top of the burner and turn the burner on high for ten to

ﬁfteen seconds for extra drying. If rust does occur, Bar Keeper’s Friend and a

blue Scotch-Brite pad will remove it. To condition grates and burner caps, apply a

light coating of mineral oil or vegetable oil. Allow oil to soak in 15 minutes before

returning grates or burner caps to cooking surface.

BURNER BASES

The base should be wiped regularly with hot soapy water at the end of each cooling period. DO NOT use steel wool, abrasive cloths,

cleanser, or powders. To remove encrusted materials, soak the area with a hot towel to loosen the material, then use a wooden nylon

spatula. DO NOT use a metal knife, spatula, or any other metal tool to scrape the aluminum base.

SEALED BURNER TOP/BURNER BOWLS

After cooking, always wipe down burner bowls and the sealed burner top with hot, soapy water and a soft cloth. If spots still occur, use

Soft Scrub cleanser (without bleach) with a blue Scotch-Brite pad. Careful, Scotch-Brite can cause scratches on the porcelain surface if

scrubbed too abrasively.

KNOBS

Remove from unit and clean with hot, soapy water and a soft cloth. Scrub gently; do not

soak. Use of abrasive cleaners or ammonia-based products could possibly remove the

graphics. Dry thoroughly before replacing.

CONTROL PANEL

Only use hot, soapy water and a soft cloth. Use of abrasive cleaners or ammonia based

products on the control panel could possibly remove the graphics.

STAINLESS STEEL SURFACES

For everyday use, start with hot, soapy water and a soft cloth. Wipe dry. Finish with a

damp micro-ﬁber cloth. Make sure to rub in the direction of the grain/brushed ﬁnish. If

anything acidic lands on it (lemon, tomato sauce, etc.) clean up immediately because it

will stain.

For optimum appearance use a stainless steel cleaner to remove smudges and

ﬁngerprints and follow up with a polish such as Thor (www.thorproducts.com) to make

unit shine. Cleaner and polish should not be used daily. Once every couple of weeks

should be adequate.

PAGE 1
CLEANING TIPS ® RANGES / RANGETOPS / OVENS GRATES/BURNER CAPS (sealed and open burners) After cooking, always wipe down grates and burner caps with a damp sponge and dry thoroughly. Normal cleaning can be done with hot, soapy water and/ or Soft Scrub cleanser (without bleach) with a blue Scotch-Brite pad. If stubborn spots still occur, then use Easy-Off Fume Free Max Oven Cleaner (see first bullet below).
PAGE 2
OVEN INTERIOR All ovens should be cleaned frequently with hot, soapy water. NON SELF - CLEANING OVENS • Oven door: For non self-cleaning ovens, use Easy-Off Fume Free Max Oven Cleaner. Apply oven cleaner with a damp sponge. • Oven racks and rack supports: Clean with hot, soapy water or Soft Scrub cleanser. Remove before self-cleaning. • Oven interior surfaces: Use Easy-Off Fume Free Max Oven Cleaner. Follow manufacturer’s directions.