User Manual
26
Product Care
Self-Clean Cycle
To start the Self-Clean cycle:
1. Close the door completely.
2. Turn the oven selector knob clockwise to the “SELF CLEAN” mode.
3. Turn the temperature control knob to the clean setting stop. At this time, the clean indicator light will come on. Within 30
seconds the automatic door latch engages and the oven indicator light comes on. The oven indicator light will remain on
until the oven reaches the self-clean temperature and will then cycle on and off during the self-clean cycle.
4. The clean indicator light will remain on until the self-clean is completed or interrupted and the oven temperature drops to
a safe temperature. A complete cycle is approximately 2-1/2 hours with an additional 30 minutes needed for the oven to
cool down enough for the door latch to disengage.
Note: A fan noise will be heard during the self-clean cycle and will continue to run for the 2-1/2 hour duration of the self-
clean cycle.
5. When the cycle is completed, turn both the oven selector and temperature control knob to the “OFF” position. When the
oven has completely cooled, open door and remove any ash from the oven surfaces with a damp cloth.
To stop the Self-Clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to
“OFF”. When the oven temperature drops to a safe temperature, the automatic door latch will release and the oven door
can be opened. When the oven has completely cooled, remove any ash from the oven surfaces with a damp sponge or
cloth.
Replacing Oven Lights
1. Unsnap glass light cover using a screwdriver in the access
groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto metal
box.
5. Reconnect power at the main fuse or circuit breaker.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main
fuse or circuit breaker before replacing bulb.
WARNING
DO NOT touch bulb with bare hands. Clean off any signs
of oil from the bulb and handle with a soft cloth.
access
groove
light
bulb
glass light
cover