Installation 3 Series Built-In Electric Cooktop RVEC330 / CRVEC330 RVEC336 / CRVEC336 RVEC345 / CRVEC345
Table of Contents Warnings & Important Safety Instructions _______________________________________________3 Dimensions _________________________________________________________________________5 Specifications _______________________________________________________________________6 Cutout Dimensions __________________________________________________________________7 Clearance Dimensions (Proximity to Cabinets) ___________________________________________8 Clearance Dimensions (Wood/Composite Overlay) ________
IMPORTANT– Please Read and Follow • Before beginning, please read these instructions completely and carefully. • DO NOT remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. • Please observe all local and national codes and ordinances. • Please ensure that this product is properly grounded. • The installer must leave these instructions with the consumer who should retain for local inspector’s use and for future reference.
IMPORTANT– Please Read and Follow WARNING CAUTION BURN HAZARD Be sure the electric power is off from the breaker box to the junction box until the cooktop is installed and ready to operate. The junction box should be connected to a suitable ground. The use of cabinets for storage above the appliance may result in potential burn hazard. Combustible items may ignite, metallic items may become hot and cause burns.
Dimensions 30” Electric Cooktop 36” Electric Cooktop 36 30 (78-3/4 .1 ” cm ) (93-3/4 .3 ” cm ) ” 21 m) .4 (53 c ” 21 cm) .4 (53 45” Electric Cooktop (1145” 4.3 c m) ” 21 cm) .4 (53 1-5/8” (4.1 cm) 3-1/8” 4-1/2” (7.9 cm) (11.4 cm) 21” (53.
Specifications Electric Cooktop Description 30”W 36”W 45”W Overall width 30-3/4” (78.1 cm) 36-3/4” (93.3 cm) 45” (114.3 cm) Overall height from bottom 4-1/2” (11.4 cm) Overall depth from rear 21” (53.3 cm) Cutout width Minimum Maximum 28-7/8” (73.3 cm) 29-7/8” (75.9 cm) 34-7/8” (88.5 cm) 35-7/8” (91.1 cm) Cutout height with conduit 4-1/8” (10.5 cm) Cutout depth Minimum Maximum 20” (50.8 cm) 20-1/4” (51.4 cm) Electrical requirements 240/208v 50/60hz Maximum amp usage 43-1/8” (109.
Cutout Dimensions B A C 30” W. 36” W. 45” W. A 28-7/8” (73.3 cm) min. to 34-7/8” (88.5 cm) min. to 43-1/8” (109.5 cm) min. to 29-7/8” (75.9 cm) max. 35-7/8” (91.1 cm) max. 44-1/8” (112.1 cm) max. B 20” (50.8 cm) min. to 20-1/4” (51.4 cm) max. C 2-1/2” (6.4 cm) min. Note: Based on 24” deep cabinet with 3/4” backsplash.
Clearance Dimensions Proximity to Side Cabinet Installation (Proximity to Cabinets) Minimum Clearances from Adjacent Combustible Construction • The cooktop may be installed directly to existing base cabinets. • The cooktop CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36” (91.4 cm) high. There must be a minimum of 6” (15.2 cm) side clearance from the cooktop to such combustible surfaces above the 36” (91.4 cm) counter height.
Clearance Dimensions The bottom of a standard hood should be 30” (76.2 cm) min. to 36” (91.4 cm) max. above the countertop. This would typically result in the bottom of the hood being 66” (167.6 cm) to 72” (182.9 cm) above the floor. Refer to the rangehood installation instructions for additional information. These dimensions provide for safe and efficient operation of the hood. (Wood/Composite Overlay) Wo o d/C o Ov mpo erl sit ay e 66 (16 ”mi 7.6 n. c 72 to m) ” (18 ma 2.9 x.
Electrical Requirements Electrical Requirements Electrical Connection Check your local codes regarding this unit. This cooktop is supplied with a 3-wire, A.C. 208Y/120 volt or 120/240 volt, 60 HZ electrical system. A white (neutral) is not needed for this unit. See next section for grounding instructions. It should be fused separately. WARNING The electrical power to the unit must be shut off while line connections are being made. Failure to do so could result in serious injury or death.
General Information READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. WARNING ELECTRICAL GROUNDING INSTRUCTIONS • All openings in the wall behind the appliance in the floor under the appliance shall be sealed • Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors. • Disconnect the electrical supply prior to servicing or cleaning. • When removing the cooktop for service and/or cleaning, disconnect AC power supply.
Installation 1 2 Green Neutral Red Black Lower cooktop into cutout. Connect the red and black leads from the unit conduit to the corresponding leads in the junction box. 4 3 Cooktop Countertop Cooktop Countertop Filler Block Screw Filler Block Eye Bolt Bracket Bracket After placing cooktop in the cutout, screw brackets to burner box with sheet metal screw.
Final Preparation • Some stainless steel parts may have a plastic protective wrap which must be peeled off. • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleaners, or powders! If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper.
Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range at 1-888-845-4641 for the nearest service parts distributor in your area or write to: VIKING RANGE, LLC PREFERRED SERVICE 111 Front Street Greenwood, Mississippi 38930 USA The serial number and model number for your appliance can be found by looking under the cooktop. Record the following information indicated below.
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-845-4641 or our website at vikingrange.com in the US or brigade.
