Table of Contents Warnings & important Safety instructions . 3 Dimensions 6 Specifications 7 Clearance Dimensions (Proximity to Cabinets} B Clearance Dimensions (Wood/Composite Overlay) .
IMPORTANT—Read and Follow! * Before beginning, please read these instructions completely and carefully. * DO NOT remove permanently affixed labels, wakings, or plates from product, This may void the warranty. » All local and national codes and ordinances must be observed.
IMPORTANT—Read and Follow! * The required use normally related fo the location of a receptacle with respect to any significant sources of water or moisture. » Viking Range, LLC will NOT warranty any problems resulting farm GF| outsets which are not installed properly or do not meet the requirements below.
A WARNING ~y ELECTRICAL SHOCK & HAZARD To avoid risk of electrical shock, personal injury or death; verify your appliance has been properly grounded in accordance with local codes or in absence of codes, with the National Electrical Code (NECK. — latest edition. A WARNING MOVING HAZARD %8 To avoid risk of severe " personal injury; this appliance requires two or more personnel while handling and moving. Possible use of appliance moving devices is recommended. A WARNING TIPPING HAZARD + THIS RANGE CAN TIP.
Dimensions PRESERVER (i35 cm) 297 37 emy ] e 2B (635 o) 2B Elem L’Q Ly FAE aweigh.
Specifications (75.9 cm) To top of glass frame (31.1 cm) min. to 37" (94.0 cm) max. Legs adjust (2.9 cm) To end of side panel—25" (63.5 cm) To front of (65.4 cm) To front of control (68.9 em) To end of knobs—29" (73.7 cm} To top of island trim—add 07 (0.0 cm) Te top of blackguard 6” (15.2 em) To top of high-shelf —add (46.2 em) 240-208 VAC 60 Hz electrical connection box on product, connect with locally supplied 3-wire, flexible cord or ~pi3mi\~ rated 40 amp. 125-250 VAC minimum.
Clearance Dimensions proximity o cabinets « This range may be installed directly adjacent to existing 367 (914 cm) high base cabinets. IMPORTANT: The side trim MUST be 378" (95 cm) above the adjacent base cabinet counter top. This can be accomplished by raising the unit using the adjustment spindles on the legs. * The range CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36" (914 om) high. There must be & minimum of 6 (15.
Clearance Dimensions wood composite overlay The bottom of a standard hood should be 307 (76.2 cm) min. 1o 36" (71.4 cm) max. above the counter top. This would typically result in the bottom of the hood being 66" {1676 em) to 72" (1829 em) abase the floor. Refer to the range hood installation instructions for additions information, These dimensions provide for safe and sufficient operation of the hood. Wall Installation Note: This range ships standard with an island trim. There is a 6” (15.
Electrical Requirements Electrical Requirements This product is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, latest edition (See Rating chart below). If local eased prohibit grounding through the neutral, use a 4-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, SAUCEPAN 70 latest edition {See Rating chart below).
General Information READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. * Al openings in the wall behind the appliance and in the floor under the appliance must be sealed. * DO NQT obstruct the flow of combustion and ventilation air. A CAUTION Avoid any damages to oven vents. The vents need to be unobstructed and open to provide proper airflow for optimal oven performance. A CAUTION The cooling fan should be operating when the unit is in operation.
Installation A CAUTION To avoid risk of personal injury or product damages, DO NOT use the handier or oven door to lift the oven. Remove door before installation to ensure that it is not used to [ift the unit. DO NOT lift or carry the door by the handle. Removing the door must be done by your dealer, or a qualified licensed plumber. Door Removal Open door completely, Gently close until latches stop door Fold latches back until lacked in place.
Leg Installation Legs ars packed i tyrannous fop pack . Nos: It is strongly commendation Note: Logs should be installed near 1o whets that a pallet or It jack b sad rather than siting. appliance is to be used, as they are False unit about a feet. Unscrew temporary legs from ot secures for long transit. couplings: Screw legs Into couplings on all . Lower range gently to keep any undue strain from. our comers. legs and internal mounting hardware.
Electrical Connection (3-wire) Note: if you have a 4-wire connection, see following section for 4-wire connection instructions. LG > @ ELECTRICAL SHOCK To avoid risk or electrical shock, personal injury or death; grounding product to the frame of the unit may or may not be permitted through your local codes. If ground to the frame is not permitted then a 4-conductor power cord must be used.
Electrical Connection (4-wire) A WARNING <, HAZARD To avoid risk or electrical shock, personal injury or death; ~ @ ELECTRICAL SHOCK grounding product to the frame of the unit may or may not be permitted through your local codes. If ground to the frame is not permitted then a 4-conductor power cord must be used.
Electrical Connection (4-wire) (cont.) Bare Wire Conn action ’ Eyelet Connection T make 2 bare wire correction, tse holes on the [eft Fend supply cord up through hols in bottom sided of the terminal black, To sonnet escalate styles of range back. wires. use Bibles on right side of terminal. Attach ground wire [green) Attach line #1 (lac and ine #2 (el with ground screw that was removed. leads to outside terminal. Attach intranet wire white) o center terminal on terminal bock.
Leveling/Adjustments/Alignment Measure the four corners in cutout area to For uneven or sipped floors, level unit with ey if flooring is label. natal shims only. as the adjustment squired may exceed the thread available in the lag. Check that unit is level side to. side and front 1o back, Side trim of the high comer st be 3/8° [0.95 cv) above counterpart. 1 leveling is required, move unit out of opening. Lift unit and prop on wood blocks.
Leveling/Adjustments/Alignment (cont.) Set the high comer of range so that the top of side im Is. 3/87 .95 om) above counter tap. Level mange to high corner. Anti-tip Device Installation N LU LT TIPPING HAZARD » THIS RANGE CAN TIP. * CHILD OR ADULT CATNIP THE RANGE AND BE KILLED. « FAILURE TO INSTALL THE ANTI-TIP DEVICE CAN RESULT IN DEATH OR SERIOUS BURNS TO CHILDREN OR ADULTS. + IF THE RANGE IS MOVED THEN THE ANTI-TIP DEVICE MUST BE RE-ENGAGED.
Locate anti tip bracket on rear wall with the top left comer st Mark and ol halos where bracket measurement (A plus 1/2° (1.3 o) from the floor and 9.2 om) will bs located, from whets the right side-of tangs (acing range) i 19 be located. Attach bracket swath mounting hardware provided. Floor Mount Anti-tip Installation Locate anti tip bracket hook on the fur Mot anti-tip Bracket hook to floor 81227 1.8 o) from sidle cabinet and (3.8 am) rom rear wal.
Hack that unit is level side to aids and front 1o back. The side tim must be 3/8° (0.95 cm) above counter top. If unit is not level repeat Steps 5.7 of "Leveling/Adjustments/Alignment” section, Door Replacement Archaically realign door on hinges. Slide In and down. Open door completely. . Close door Fold latches forward until locked in place.
Final Preparation * Al stainless testes body pants should be wiped with hot, soapy water and with a liquid cleaner designed for this material.
Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing shooed be referred to a qualified technician, Contact Viking Range, [1C, 1-888-845-4641, for the nearest service parts distributor in your area or write fo: VIKING RANGE, LLC PREFERRED SERVICE 111 Front Street Greenwood, Mississippi 38930 USA Range The serial number and medal number for your appliance can be found by opening the door and looking under the control! panel.
F21193AEN Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 4551200 Eor product information, call 1-888-845-4641 or visit our website at vikingrange.com in the US or brigade.
