Installation Instructions

8
General Information
• When installing this unit directly below
other units, only install with Viking built-
in products.
• Remove warming drawer carefully from
carton. Remove all loose packaging and
accessories.
• It is the responsibility of the installer to
comply with local codes. If no local
codes are applicable, wire in accordance
with the National Electrical Code,
ANSI/NFPA-70 – latest edition.
• This appliance is not fused. Protect
with a proper sized fuse or circuit
breaker and a GFI for outdoor models.
• Line disconnect switch, circuit breaker,
GFI (for outdoor models) or plug/
receptacle of power cord connection
should be readily accessible to the
operator.
• Ground unit per applicable electrical
codes.
• Any installation not matching the
specifications discussed in these
instructions will void the manufacturer’s
warranty.
READ AND FOLLOW ALL WARNING AND
CAUTION INFORMATION WHEN
INSTALLING THIS APPLIANCE.
Moving, Handling and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the outside
and inside of the warming drawer.
Some stainless steel parts may have a plastic
protective wrap which must be peeled off. The
interior should be washed thoroughly with hot,
soapy water to remove film residues and any
dust or debris before being used, then rinsed
and wiped dry. Solutions stronger than soap
and water are rarely needed.