Installation Guide

7 EN
Refrigerator / User Manual
4 Installation
To reduce the risk of fire, electrical shock, or injury to
persons, installation work and electrical wiring must
be done by a qualifi ed technician in accordance with
all applicable codes and standards, including fire-rated
construction.
It is the customer’s responsibility to:
• Contact a qualified electrical installer.
• Assure that the electrical installation is
adequate and in conformance with the
National Electrical Code, ANSI/NFPA 70-latest
edition or Canadian Electrical Code C22.1-
1998 and C22.2 No. 0-M91 (or latest
edition), and all local codes and ordinances.
Product must not be plugged in during
installation. Otherwise, there is the risk of death
or serious injury!
WARNING: Installation and electrical
connections of the product must be carried out
by the Authorzed Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out by
unauthorized persons.
WARNING: Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks
for your safety.
Make sure that the power cable is not pinched
or crushed while pushing the product into its
place after installation or cleaning procedures.
Appropriate installation location
WARNING: If the door of the room where
the product will be placed is too small for the
product to pass, then the product's doors
must be removed and the product must be
turned sideways to pass it through.
• Install the product at least 12” (30 cm) away from heat
sources such as gas cooktops, ovens, and stoves and
at least 2” (5 cm) away from electrical ovens. Product
must not be subjected to direct sun light and kept in
humid places after installation.
• Do not place the product on rugs or carpets.
• Place the product on an even floor surface to prevent
wobbling.
• Do not install the product in places where the
temperature falls below 10ºC /50°F.
If two refrigerators are to be installed side
by side, there should be at least 1-1/2” (4
cm) distance between them.
Built-In Installation
If the product will be placed in a cutout, make sure
sufficient room is provided around the appliance to ensure
free air circulation.
To ensure proper ventilation:
- Allow for a 5/8” (1.6 cm) space on each side and 2” (5.1
cm) at the top.
-Allow 1-3/8” (3.5 cm) of space behind the refrigerator
.
Proper Circulation
For efficient functioning in the cutout, the metal bracket
and air buffer bumpers must be added to product.
Unscrew before the installation
Install the vertical metal
bracket and screw.
The longer screw must
be used on the top.