Installation Guide 2

33
Surface Burner Conversion
Surface Burner Conversion
-Locate appropriate orifi ce
-Remove screw (Item #1) fl at-head screwdriver.
- Lay the burner fl ange to side - do not disconnect the igniter wire.
(Item #2).
-Use a nut driver to remove orifi ce (Item #3).
-Replace with correct orifi ce - refer to next page.
Tech tip: Tape can be applied to the inside of the socket to assist
in the removal of the surface burner orifi ces. This can
prevent the orifi ces from falling into the range during
removal.
- After replacing the orifi ce, replace Item#2 burner fl ange.
-Reinstall screw and reverse procedure to reassemble.
NOTE: For proper placement of the burner head, rotate until
burner head seats into groove.
Frenchtop Burner Conversion
-Remove frenchtop plate.
-Remove screws around burner.
-Remove screws holding burner box.
-Slide burner box forward and lift out.
-Orifi ce is located under orifi ce bracket, attached to tubing.
-Use a nut driver to remove orifi ce.
Tech tip: Tape can be applied to the inside of the socket to assist
in the removal of the surface burner orifi ces. This can
prevent the orifi ces from falling into the range during
removal.
- After replacing the orifi ce, reinstall burner box and frenchtop plate
Item #1
Item #2
Item #3
Orifi ce bracket
Orifi ce
Remove grates, surface burner caps and frenchtop (if applicable)