Installation Guide

33
Surface Burner Conversion
Surface Burner Conversion
-Locate appropriate ori ce
-Remove screw (Item #1)  at-head screwdriver.
- Lay the burner  ange to side - do not disconnect the igniter wire.(Item
#2).
-Use a nut driver to remove ori ce (Item #3).
-Replace with correct ori ce - refer to next page.
Tech tip: Tape can be applied to the inside of the socket to assist in the
removal of the surface burner ori ces. This can prevent the
ori ces from falling into the range during removal.
- After replacing the ori ce, replace Item#2 burner  ange.
-Reinstall screw and reverse procedure to reassemble.
NOTE: For proper placement of the burner head, rotate until burner
head seats into groove.
Item #1
Item #2
Item #3
Remove grates, surface burner caps and frenchtop (if applicable)