Viking Use/Installation Guide Outdoor Cabinets
IMPORTANT - PLEASE READ AND FOLLOW •Before beginning, please read these instructions completely and carefully. •Do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty. •Viking outdoor stainless steel cabinets are not designed to be water tight. Water may enter cabinetry under certain conditions •The installer should leave instructions with the consumer who should retain for future reference •NEVER use LP tanks inside any stainless steel cabinetry.
5. Place cabinet(s) in approximate final position. Level cabinets using leveling legs. Use 1/2" SMS screws provided to screw cabinets together. (See illustration #3). Illustration #3 Install 4 Tinnerman clips (provided) before fastening cabinets together Mount cabinets with #10 x 1/2” screws provided 6. Determine appropriate hinge side for cabinets with interchangeable doors. Remove outside door panel. Install hinges by placing plate in hole in door and fasten in place with hardware provided.
8. If desired, snap toe kick included with each unit to front legs. (See illustration #6). Illustration #6 Snap toe kick to front legs 9. SIDE PANEL INSTALLATION (End of Run Only) •Remove all drawers. (If applicable) •Remove all protective covering from panel and install using the #10 x 1/2” tek screws provided. (See Illustration #7) •Attach toe kick to legs (See Illustration #6). NOTE: FOR WALL INSTALLATIONS: The front portion of the side toe kick must be shortened to match the front toe kick.
10. BACK PANEL INSTALLATION •Remove all protective covering from panel and install using the #10 x 1/2” tek screws provided. (See Illustration #8). •Attach rear toe kick to legs. (See illustration #8). NOTE: For end of the run panels, the rear, front, and side toe kicks must be modified. (See illustrations #7 & #8) 2. Fasten from inside with (4) 1/2” tek screws provided Illustration #8 Back panel 1. Place back panel onto cabinet area 3.
BASIC SPECIFICATIONS OVERALL WIDTH OVERALL HEIGHT OVERALL DEPTH VBBO1601 VBBO2602 VBO1811, including doors VTPO1810, including doors VBO1830, including doors VSBO2402, including doors VSBO3602, including doors VQBO3021, VQWO3010 VQBO4121, VQWO4120 VQBO5322, VQWO5311 VERO3200 15 5/8” (39.7 cm) 26 3/8” (67.0 cm) 18” (45.7 cm) 18” (45.7 cm) 18” (45.7 cm) 24” (61.0 cm) 36” (91.4 cm) 30 1/4” (76.8 cm) 41 7/8” (106.4 cm) 53 7/8” (136.8 cm) 32” (81.3 cm) 34 1/2” (87.6 cm) 34 1/2” (87.6 cm) 34 1/2” (87.
CARE AND MAINTENANCE CAUTION •Do not use a metal knife or any other metal tool to scrape stainless steel parts. •Do not permit citrus or tomato juice to remain on stainless steel surfaces, as citric acid will permanently discolor stainless steel. Wipe up any spills immediately. •Do not use abrasive cleaners, steel wool pads, or abrasive cloths as they will scratch the product. 1. Carefully remove protective plastic peel coat from each stainless steel surface.
Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For more product information call 1-888-VIKING1 (845-4641), or visit the Viking Web site vikingrange.
