Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com F1571S EN Built-In 18” H.
NOTE: IF INSTALLING HOOD WITH WARMING SHELF PANEL, INSTALL WARMING SHELF PANEL FIRST. CAUTION IMPORTANT - PLEASE READ AND SAVE THESE INSTRUCTIONS •Before beginning, please read these instructions completely and carefully. •Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. •Please observe all local and national codes and ordinances. If no local codes are applicable, wire in accordance with the National Electrical Code, ANSI/NFPA 70-1990.
HEIGHT OF INDOOR HOOD PREPARING FOR HOOD INSTALLATION The bottom of the hood should be 30” (76.2 cm) min. to 36” (91.4 cm) max. above the countertop. This would typically result in the bottom of the hood being 66” (167.6 cm) to 72” (182.9 cm) above the floor. The bottom of the hood should never be more than 72” (182.9 cm) above the floor or more than 36” (91.4 cm) above the countertop. These dimensions provide for safe and efficient operation of the hood. Plan where the ductwork will be located.
INSTALLING HOOD CANOPY (VBCV/VICV Custom Ventilator Kits Only) INSTALLING ROUGH-IN PLATE AND CONNECTING DUCT - INTERNAL POWER Wall Hoods A A* B* B 30” W. 27 7/16” (69.7 cm) 21 7/16” (54.5 cm) 36” W. 33 7/16” (84.9 cm) 21 7/16” (54.5 cm) 42” W. 39 7/16” (100.2 cm) 21 7/16” (54.5 cm) 48” W. 45 7/16” (115.4 cm) 21 7/16” (54.5 cm) 54” W. 51 7/16” (130.7 cm) 21 7/16” (54.5 cm) 60” W. 57 7/16” (145.9 cm) 21 7/16” (54.5 cm) 66” W. 63 7/16” (161.1 cm) 21 7/16” (54.
INSTALLING THE VENTILATORS INSTALLING ROUGH-IN PLATE AND CONNECTING DUCT -EXTERNAL POWER VIV300 or VIV600 - Interior-Power Ventilator Kit (300 or 600 CFM) (also see instructions supplied with ventilator kit) 1. Make sure barrel nuts and wing nut are engaged halfway onto threaded stud. 2. Lift ventilator into canopy - may be easier to turn ventilator side ways to lift into canopy then rotate into mounting position. 3. Lift ventilator allowing barrel nuts to come through large end of keyhole opening.
ROOF INSTALLATION EXTERIOR-POWER VENTILATOR WALL INSTALLATION EXTERIOR-POWER VENTILATOR ROOF CUTOUT VEV900-Exterior Power Ventilator Kit (900CFM) (also see instructions supplied with ventilator kit) 1. Locate the blower on the rear slope of the roof. Place it in a location to minimize duct run. The location should be free of obstacles (T.V. leads, electrical lines, etc.). Bear in mind, if the blower top is level with the roof peak, it will not be seen from the street.
ROOF CUTOUT ROOF INSTALLATION EXTERIOR-POWER VENTILATOR Exterior Power Ventilator B (also see instructions supplied with ventilator kit) 1. Locate the blower on the rear slope of the roof. Place it in a location to minimize duct run. The location should be REMOVE SHINGLES free of obstacles (T.V. leads, electrical lines, etc.). Bear in 11 12 /16” mind, if the blower top is level with the roof peak, it will (32.2 cm) not be seen from the street.
EXTERIOR VENTILATOR DIMENSIONS WALL HOOD DIMENSIONS (Indoor/Outdoor VWH Models) VEV1200 VEV1500 VEV900 Transition VIV1200 Only Opening for wiring 12” (30.5 cm) 1 1/2” (3.81 cm) 10” Dia. A 9” (22.9 cm) 1” (2.54 cm) 1 1/2” (3.81 cm) 7/8” (2.22 cm) 1 29 /2” (74.9 cm) 203/4” (52.7 cm) 18” (45.7 cm) 281/4” (71.8 cm) 18” (45.7 cm) 1 10 /8” 6” (15.2 cm) 25.7 cm 241/2” (62.2 cm) 151/2” (39.4 cm) 24” (61.0 cm) or 27” (68.6 cm) 1 10” (25.4 cm) Dia. 22 /8” (56.2 cm) 24” (61.0 cm) or 27” (68.
BUILT-IN CUSTOM VENTILATOR SYSTEM DIMENSIONS (VBCV Models) Transition VIV1200 Only 9” (22.9 cm) B 18 1/2” (50 cm) B 1 1/2” (3.81 cm) 1 1/2” (3.81 cm) 9 3/8” 8 3/16” 5 15/16” (15.1cm) 1” (2.54 cm) 7/8” (2.22 cm) (23.8 cm) 5/8” (1.6 cm) (20.7 cm) 5 1/2” 6 5/8” (16.8 cm) 9 3/4” (24.8 cm) 120 V (14.0 cm) 120 V 3” (7.62 cm) 2 1/2”(6.35 cm) 11 1/2” (29.2 cm) 8 3/8” 9 1/4” 9 1/2” (23.5 cm) (24.1 cm) (21.3 cm) 17 1/4” (43.8 cm) 5/8” (1.6 cm) 21 7/8” (55.8 cm) 10” (25.4 cm) dia.
5 1/2” (14.0 cm) 8 1/4” (20.9 cm) D 18 1/2” (50.0 cm) D 5 1/2” (14.0 cm) D 9 3/8” (23.8 cm) D 6” (15.2 cm) 9 1/4” (23.5 cm) 5/8” (1.6 cm) C C 48”, 54”, 60”, 66” W. Models 1200 or 1500 CFM EXTERIOR VENTILATOR INSTALLATION 30”, 36”, 42”, 48”, 54”, 60”, 66” W. Models 1200 CFM INTERIOR VENTILATOR INSTALLATION C W. W. W. W. W. W. W. Models Models Models Models Models Models Models 28 34 40 46 52 58 64 12” (30.5 cm) 3” (7.62 cm) 120 V (11.7 cm) 30” (76.
B BUILT-IN CUSTOM VENTILATOR SYSTEM DIMENSIONS (VICV Models) 18 3/4”(47.6 cm) B Transition VIV1200 Only 7/8” (2.2 cm) 8 1/4” (21.0 cm) 1 1/2” (3.8 cm) 1 1/2” (3.8 cm) 1” (2.5 cm) 11/16” (1.7 cm) 11 1/2” (29.2 cm) 9” (22.7 cm) 5 3/4” 5 3/4” (14.6 cm) 6” (15.2 cm) (14.6 cm) 3”(7.6 cm) 17 1/4” (43.8 cm) Cutout for 10” (25.4 cm) duct 10” (25.4 cm) duct location 2 1/2” (6.4 cm) 6” (15.2 cm) 27 7/16” (69.7 cm) 27 7/16” (69.
22 23