Quick Start Guide

17
Leveling Unit
Once the unit is in position, height adjustment can be made
from the front. Remove panel just below the water  lter.
Using a 5/16" hex drive, turn clockwise to raise the unit or
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the leveling legs
by hand. When the unit is properly leveled, door/drawer
adjustments are less likely to be necessary.
IMPORTANT NOTE: Level the unit to the  oor, not
surrounding cabinetry. This could a ect the operation of the
unit, such as door closing.
A
B
Front Panel
Left Front
Adjustment
Right Front
Adjustment
Left Rear
Adjustment
Right Rear
Adjustment
Kickplate Installation
After the unit has been adjusted to the proper height, place the kickplate on the lower front with the adjustment
screws in the slots. Let the kickplate drop until it hits the  oor. Tighten the screws.
kickplate
Front of unit
Adjustment screws
Adjustment slot