Installation Instructions

2
Parts included Tools Needed
Heater (1)
Center Trim Brackets (2)
Center Trim (1)
Top Connecting Plate (1)
Rear Connecting Plate (1)
1/4”-20 x 3/4” Connecting Plate Fasteners (6)
#8-18 x 1/2” Heater Fasteners (3)
Drill (Not to be used on the leveling feet)
Drill Bits - 3” Phillips (PH2), Torx (T15 & T20)
1/4” & 5/16” Hex Drive
Rubber Mallet
3/8” Wrench
1/8” Allen Wrench
Parts Included ____________________________________________________________________________________________2
Tools Needed ____________________________________________________________________________________________2
Cutout dimensions ________________________________________________________________________________________3
Speci cations ____________________________________________________________________________________________4
Anti-tip location __________________________________________________________________________________________7
Preparing Units for Installation ______________________________________________________________________________8
Installation ______________________________________________________________________________________________10
Table of Contents
NOTE: These instructions include information on how to install multiple 7 Series refrigeration units. For information on
dimensions, speci cations, and installation of single units, please refer to the installation guide included with the appliances.
WARNING
TIP OVER HAZARD
Appliance is top heavy and tips easily when not completely
installed. Keep doors closed until appliance is completely installed
and secured per installation instructions.
Use two or more people to move and install appliance. Failure to do
so can result in death or serious injury.
8-18 x 1/2” Heater Fasteners (Item 7)
Rear Connecting Plate (Item 5)
Top Connecting Plate (Item 4)
1/4”-20 x 3/4” Connecting Plate
Fasteners (Item 6)
Heater (Item 1)
Center Trim Brackets (Item 2)
Center Trim (Item 3)