Installation Sheet

29
28
Securing Your Wine Cellar
Before moving the wine cellar in place, confirm the finished dimensions, electrical location,
minimum door and shelf clearances, and door panel instructions.
1. Position wine cellar in front of cutout.
2. Verify operation by plugging power
cord in receptacle. Power switch will
be shipped in the “ON” position
and showroom switch will be in the
“OFF” position. (If showroom switch
is switched to the “ON” position,
showroom mode is engaged and
power is shut-off to the compressor.
This mode is for showroom display
only).
3. Roll wine cellar into cutout to within
3” (7.6 cm) of being flush with
cabinets. To avoid kitchen cabinet
damage, place cardboard between
cabinets and wine cellar. Push
cardboard back with wine cellar and
remove cardboard when wine cellar is
in place.
Power ON/OFF
Switch
Showroom
Switch
4. Lift the wine cellar off the rollers, adjust to desired height and level wine cellar by using a 5/16” hex
head wrench. (Refer to Figure at the right)
a) To raise/lower right side rear, rotate the right
side rear hex rod.
b) To raise/lower the left side rear, rotate the
left side rear hex rod.
c) To raise/lower the right side front, rotate the
right side front hex rod.
d) To raise/lower the left side front, rotate the
left side front hex rod.
NOTE: DO NOT use an electric driving device.
Overtightening can cause damage.
5. Align wine cellar with sides of cabinets by adjusting leveling legs. Rotate leveling legs until firmly in
place against floor.
6. To secure wine cellar, raise unit until compartment cover is firmly seated under the soffit or anti-tip
boards.
7. Open door. Control panel should be lit. Verify the position of the power on/off and showroom switch
if there is no power to wine cellar.
DETAIL “A”
LEFT SIDE RIGHT SIDE
DETAIL “B”
FRONT REAR FRONT REAR
LEVELING
LEGS
LEVELING
LEGS
A
B
VIEW SHOWN WITH KICKPLATE REMOVED
Kickplate Installation
Attach to
unit with
these screws
Screws and slots
for adjustments
The kickplate consists of a two (2) part assembly: one top louvered panel and one bottom solid
panel. Install the kickplate with louvered section on the top. Flooring must allow the kickplate to
be removed.
To install:
1. Insert the bottom (solid) panel into the open end of the top (louvered) panel. The holes in
the bottom panel should line up with the slots in the top panel.
2. Position the kickplate assembly along the front edge of the wine cellar.
3. Align the holes on both ends of the top (louvered ) panel with the holes in the base of the
wine cellar.
4. Attach the kickplate to the wine cellar on each side with the two black phillips head screws
provided.
5. Adjust the bottom (solid) panel to the desired height and fasten in place by tightening the
screws in the slots. There is approximately 1” (2.5 cm) of vertical adjustment on the
kickplate.