Use and Installation Guide

Installations using FLEX BLOWER only:

6. Attach BLOWER SUPPORT LEGS with (4) BOLTS provided.

BLOWER

SUPPORT

LEGS

(4) BOLTS

CAUTION: If  ex blower will be mounted remotely:

Do not use legs alone for support. It may be

necessary to add extra support for the  ex blower.

Use mounting brackets supplied with the blower.

Installations ducting through left, right, below or rear only:

(Requires purchase of 1-7/8" x 19" to 8" or 10" round transition

or 1-7/8" x 19" duct adapter with rectangular duct cut to

appropriate length.)

7. Use nuts to connect 1-7/8” x 19” rectangular ductwork

connection adapter or 1-7/8” x 19” to 8” or 10” round

transition to housing when installing ductwork.

CUT COUNTERTOP OPENING

1. Lay out and cut the cooktop cut-out far enough FORWARD

so downdraft will  t behind it.

2. Set cooktop in place and slide it as far forward as possible

without exposing an gaps. Center and square it with edges

of countertop.

3. Place the plastic template against the back  ange of the

cooktop or back edge of slide-in range countertop opening.

Center the template. Trace around template to mark the

downdraft opening.

4. Remove cooktop from countertop.

5. Cut downdraft opening. Be careful not to chip edges of

countertop.

Template against back

edge of cooktop.

COOKTOP