Installation Instructions

6
Surface Burner Conversion
Front Surface Burner Conversion
Item #1
Item #2
Item #3
Front of unit
Top View of
Venturi flange
Burner
Head
-Locate bag labeled 050300-000
-Remove screws (Item #1) with a T-20 Torx bit.
-Remove venturi fl ange (Item #2).
-Use a metric 10mm nut driver to remove orifi ce (Item #3).
-Replace orifi ce with #44 from 050300-000 bag. The orifi ce
will have a violet color code ink and 052 stamped on the
orifi ce.
Tech tip: Tape can be applied to the inside of the socket
to assist in the removal of the surface burner
orifi ces. This can prevent the orifi ces from
falling into the range during removal.
- After replacing the orifi ce, replace Item#2 venturi fl ange
with venturi fl ange labeled 050576-000. Note orientation
of venturi fl ange (refer to Top view of Venturi fl ange).
-Reinstall screws and reverse procedure to reassemble.
NOTE: For proper placement of the burner head, rotate
until burner head seats into groove.
Rear Surface Burner Conversion
Item #1
Item #2
Item #3
Front of unit
Top View of
Venturi flange
Burner
Head
-Locate bag labeled 050300-000
-Remove screws (Item #1) with a T-20 Torx bit.
-Remove venturi fl ange (Item #2).
-Use a metric 10mm nut driver to remove orifi ce (Item #3).
- Replace left rear orifi ce with .048” from 050300-000 bag.
The orifi ce will have a dark green color code ink and 032
stamped on the orifi ce.
- Replace all other rear orifi ces with #51 from 050300-000
bag. The orifi ce will have a yellow color code ink and 042
stamped on the orifi ce.
Tech tip: Tape can be applied to the inside of the socket
to assist in the removal of the surface burner
orifi ces. This can prevent the orifi ces from falling
into the range during removal.
- After replacing the orifi ce, reinstall the current Item#2
venturi fl ange (it will not be replaced). Note orientation of
venturi fl ange (refer to Top view of Venturi fl ange).
-Reinstall screws and reverse procedure to reassemble.
NOTE: For proper placement of the burner head, rotate until burner head seats into groove.
Preparing for Top Surface Conversion
Remove all grates, grate supports, surface burner caps, and griddle
NOTE: Some models may not be equipped with all parts mentioned above.
IMPORTANT: For models equipped with griddles, notice position of griddle temperature probe for
proper reinstallation. Failure to properly reinstall could result in damage to griddle temperature probe.