Installation Guide Rear Trim/Curb Base Accessories 7 Series Ranges/Rangetops
Rear Trim Accessories WARNING To reduce the risk of fire or injury to persons, check to make sure all packaging has been removed from the outside and inside parts of the rear trim device before installing. MAKE SURE ALL CORRUGATED MATERIAL IS REMOVED FROM INSIDE THE HIGH SHELF. ATTACHING REAR TRIM (Island Trim, 10” H. Backguard OR 24” H. High Shelf Back Panel) 1. Remove the grate supports in order to locate the rear flange and mounting stud on the unit.
Rear Trim Accessories Screw Locations Regulator NOTE: Regulator will be visible after rear trim accessory is installed. X 24” H. High Shelf After installing the high shelf back panel on the range/ rangetop, place the top rolled edge on the shelf (X) over the front lip of the high shelf back panel. Secure with the (4) enclosed #10 -24x 1/2” (1.3 cm) PH machine screws Screw locations (two on each side underneath shelf ) IMPORTANT: USE OF ISLAND TRIM WITH AND WITHOUT 6” (15.2 CM) REAR CLEARANCE.
Rear Trim Accessories COUNTERTOP REAR TRIM 1. Locate screw hole openings (A) on the back of the island trim near the top. 2. Align screw hole openings on the countertop rear trim with the ones on the back of the island trim. 3. Attach rear trim to island trim with enclosed #10 x 1/2” (1.3 cm) PH Tek screws.
Curb Base Accessories STANDARD CURB BASE FRONT 1. The standard curb base front (A) is completely assembled. 2. Remove the assembly from the carton and simply clip onto the front range legs. 3. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet toe front is possible. Loosen bracket bolts on each side, but allow snug fit. Clip assembly onto range legs; determine front to back setting; remove, tighten bolts, and reattach.
Curb Base Accessories CUSTOM CURB BASE FRONT 1. Remove the standard curb base front assembly from the carton. 2. Remove the front (A) from the mounting assembly (B). 3. Attach locally supplied front (C) to the mounting assembly (B) and simply clip onto the front range legs. Important Note: The locally supplied front must not be any taller than 3-1/8” (7.9 cm) tall. Fronts taller than 3-1/8” (7.9 cm) could obstruct the airflow. 4. The assembly is adjustable about 2” (5.
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit the Viking Web site at vikingrange.com in the U.S. or brigade.ca in Canada.
