Accessory Installation Guide

(Illustration II)

Grasp the trim on each end and carefully place in the channels (B) located at each rear corner of the

product. Align the screw holes (A) at each end of the trim device with the holes (A) in each rear channel

of the product. Secure with the 4 enclosed screws.

RANGETOP

REAR VIEW

RANGE REAR

VIEW

(Illustration I)

HIGH SHELF

Rear Trim Accessories

Backguards come equipped with Nylon Spacers (See Figure 1), which are needed to space the

range off a combustible wall a prescribed safe distance.

Note: If the back wall is Non-Combustible, these spacers can be removed. (See Figure 2)

These spacers can also be removed if used with any of the models listed below:

• 30”, 36” and 48” VGCC

• VDSC530

• VDSC536

• VGRT530

• VGRT536

ATTACHING REAR TRIM (Illustration I)

ATTACHING SHELF ON HIGH-SHELF (Illustration II)

All rear trim devices are installed in the same basic way.

Place the top rolled edge (X) over the front lip of the high-shelf back trim and secure with the 4

enclosed screws, two at each end.

W A R N I N G

To reduce the risk of fire or injury to

persons, check to make sure all packaging

has been removed from the outside and

inside parts of the rear trim device before

installing. MAKE SURE ALL CORRUGATED

MATERIAL IS REMOVED FROM INSIDE

THE HIGH SHELF.

NOTE: High shelf is already installed on

Designer models.

ATTACHING BACKGUARD (Illustration III)

Figure 1

(Illustration III)

Figure 2

On VGSC530, VGSC536 and VGSC548 models there is a regulator cover supplied with the

backguard that must be attached to the oven, with the supplied screws, before the backguard

is attached. (See Figure 3)

Figure 3

*If you have one of these models, the

spacers are not required, even if with a

combustible wall.