manual

10
Surface Operation
Our ranges are equipped with an exclusive VSH™ (VariSimmer-to-high) Pro Sealed burner System. This unique burner system is equipped
with 15,000 BTU burners and one 18,500 front burner.
Lighting Burners
All burners are ignited by electric ignition. There are no open-flame, standing” pilots.
Surface Burners-Automatic Reignition
To light the surface burners, push and turn the appropriate control knob counter clockwise to any position.
This control is both a gas valve and an electric switch. Burners will ignite at any “ON” position with the
automatic re-ignition system. If the flame goes out for any reason, the burners will automatically reignite if
the gas is still flowing. When gas is permitted to flow to the burners, the electric igniters start sparking. On
all surface igniters you should hear a clicking” sound. If you do not, turn off the control and check that the
unit is plugged in and that the fuse or circuit breaker is not blown or tripped.
Within a few moments, enough gas will have traveled to the burner to light. When the burner lights, turn
the burner control to any position to adjust the flame size. Setting the proper flame height for the desired
cooking process and selecting the correct cooking vessel will result in superior cooking performance, while
also saving time and energy.
Vari-Simmer™
Simmering is a cooking technique in which foods are cooked in hot liquids kept at or just barely below the boiling point of water.
Simmering ensures gentler treatment than boiling to prevent food from toughening and/or breaking up. The size of the pan and the
volume of food can have a significant effect on how high or low a flame is needed for simmering. For this reason, Viking range and
rangetop burners are engineered with a Vari-Simmer setting. The Vari-Simmer setting is not just one simmer setting, but provides a variable
range of simmer settings. This variable range of simmer settings allows you to adjust the flame height to achieve the best simmer
depending on the type and quantity of food being simmered. It is this ability that makes the Vari-Simmer setting the most accurate and
trustworthy simmer on the market.
Surface Cooking Tips
Use low or medium flame heights when cooking in vessels that are poor conductors of heat, such as glass, ceramic, and cast-iron.
Reduce the flame height until it covers approximately 1/3 of the cooking vessel diameter. This will ensure more even heating within
the cooking vessel and reduce the likelihood of burning or scorching the food.
Reduce the flame if it is extending beyond the bottom of the cooking vessel. A flame that extends along the sides of the vessel is
potentially dangerous, heats the utensil handle and kitchen instead of the food, and wastes energy.
Reduce the flame height to the minimum level necessary to perform the desired cooking process. Remember that food cooks just
as quickly at a gentle boil as it does at a rolling boil. Maintaining a higher boil than is necessary wastes energy, cooks away
moisture, and causes a loss in food flavor and nutrient level.
The minimum pot or pan (vessel) diameter recommended is 6” (15 cm). Use of pots or pans as small as 4” (10 cm) is possible but not
recommended.
TruPower Plus™ Burner (where applicable)
Certain model ranges are equipped with a TruPower Plus burner in the front right burner position. This burner is designed to provide
extra high heat output, especially when using large pans, and should be used for boiling large quantities or if you need to bring
something to a boil quickly. While TruPower Plus burner has the extra power needed to bring large quantities of liquid to a boil
rapidly, it is also able to be turned down low enough to provide a very low and delicate simmer making this burner the most versatile
burner on the market.