Installation Instructions

17
1
Remove access door.
Electrical Connection (3-wire) - Dual Fuel Ranges
Note: If you have a 4-wire connection, see following section for
4-wire connection instructions.
2
Remove supply cord strain relief
bracket and three supply cord mounting screws
on terminal block.
WARNING
Electrical shock hazard.
To avoid risk or electrical shock,
personal injury or death;
grounding product to the frame
of the unit may or may not be permitted
through your local codes. If ground to the
frame is not permitted then a 4 conductor
power cord must be used.
WARNING
Electrical shock hazard.
To avoid risk of electrical shock,
personal injury or death; verify
your appliance has been properly
grounded in accordance with local codes or
in absence of codes, with the National
Electrical Code (NEC). ANSI/NFPA 70-latest
edition.
3
Feed supply cord up through hole in bottom
of range back.
See Electrical Requirements information.
Where local codes do not permit grounding
through neutral, use a 4-wire power supply cord.
The cord or conduit must be secured to the range
with the strain relief bracket.
The electrical connection is made at the terminal
block, which is located behind the access door on
the back of the range.
Installation - Dual Fuel Ranges