Specifications

VIKING RANGE, LLC Downdraft Ventilators

INSTALLATION OF REMOTE CONTROL SWITCH

1. Using the template below, lay out the 3-hole pattern on the

counter top. Mark the centers of the three holes to be drilled.

2. Carefully drill the three holes through the counter top. Be

careful not to damage or chip the counter top surface when

drilling the holes.

WARNING: To reduce the risk of burns or ignition

of clothing by reaching across burners, the remote

control must be mounted at least 4" away from

any cook top burner.

Keep in mind you do not want to place the control where it

will be in the way for cooking, or where hot pans could be

set, or hot liquids spilled on the control.

3. Remove the control from the plastic bag. Remove the paper

from the adhesive back of the control, line the control up

with the three holes and position the control so it is parallel

with the front of the counter top. Press down ﬁ rmly for 60

seconds.

4. Remove the two nylon thumbnuts from the plastic bag and thread

onto the two studs on the control from below the counter top.

Hand tighten only. The thumbnuts just need to be snugged

by hand. They are there to hold the control in place until the

adhesive sets up.

5. Remove cable from the plastic bag and plug into back of

control from below counter top. Route cable through cabinet

to lower right hand corner of downdraft. Plug other end of

cable into the downdraft unit. (Receptacle hole for cabinet

is on the lower right hand side of the downdraft.)

6. Stuff excess cable out of the way and secure the cable so it

is not damaged from items stored in the cabinet.

TOP EDGE

CUT OUT ON DOTTED LINE

1/4" DIA.

HOLE

1/4" DIA.

HOLE

1" DIA.

HOLE