Installation / Use & Care Manual

18
|
INSTALLATION / USE & CARE
GA
S
CO
NNE
C
TI
O
N
S
.
..
co
n
t
in
u
e
d
Insert the regulator inlet into the cylinder valve and turn the
black coupler clockwise until the coupler is hand tight. Do not
over-tighten this connection.
To disconnect the coupler,  rst make sure the main cylinder
valve is turned o . Grasp the coupler and turn counter
clockwise. The inlet will then disengage.
Always leak-test the connection after re lling or exchanging LP
cylinders. (See INDEX: “Leak Test” for further details.)
GAS LINE PURGING
You should purge the gas line of air before attempting to light
the grill.
• Make sure all grill controls are in the “OFF” position.
• Slowly turn on the main gas supply.
• Push in the rotisserie knob and con rm that the igniter
is glowing. It is furthest from the fuel source and will
completely purge the lines. It will take several seconds for the
burner to light.
• Hold the knob ON for about 20 seconds to allow the air in the
system to purge and the burner to light
• Wait at least 5 minutes after shutting o the control before
attempting to light the burners.
GAS CONVERSION KITS
Gas conversion kits are available from Viking Range to allow
the grill to operate on either Natural gas or LPG. These kits
should be installed by a quali ed technician.
The kits come with complete installation instructions. These
instructions should be read completely and fully understood
before installing the conversion kit.
L
P CONVERSION KI
T
NG CONVERSION KI
T
NG AND BULK LP BUILT-IN IN
S
TALLATI
ON
•Shut o the gas suppl
y
at the main valve
.
•If connecting to a bulk propane tank, disconnect the brass
elbow, hose and re
g
ulator
f
rom the
g
rill.
gg
•Remove all  ttin
g
s from the
g
rill manifold
.
•Connect the gas supply to the grill as shown in the diagram
on t
h
is pa
g
e
.
•Turn the gas supply on and leak test all connections. (See
INDEX
:
“Le
ak
Test”
fo
r
fu
rt
h
er
d
et
a
i
l
s
.
gy
y
Never r
u
n  ex h
o
se
b
ehin
d
the  re
bo
x
.
R
u
n the h
o
se
a
t
a
n
an
g
le, strai
g
ht down or out of the back
Inline Regulator
1/2” MxF
Street
Elbow
Angle At Least
20˚ From Horizon
Grill Manifold
1/2” MIP
Fitting
Flexible Gas Line to Inlet