Installation Guide

INSTALLATION / USE & CARE
|
17
F
or
f
reestandin
g
units usin
g
natural
g
as, usin
g
a metal fl e
x
hose is recommended.
This is available at your local hardware store or from your
d
ealer
.
LP
G
A
S
Grills set u
p
for LP gas come e
q
ui
pp
ed with an LP hose/
regulator assembly for connection to a standard 20 lb.
LP cylinder. (Ty
p
e 1). All fi ttings necessary to attach the
assembl
y
to the
g
rill are included.
Permanent
l
y p
l
um
b
e
d
LP connections, suc
h
as t
h
ose in
l
ine
with a bulk cylinder, require a 4/11 regulator
.
When using the 4/11 regulator you must ensure that it
is set for the
p
ro
p
er fuel ty
p
e. This is done by removing
the regulator ca
p
and gasket and looking at the bottom
of the plunger to see what fuel type is visible. This is the
regulator fuel setting. NAT is for natural gas and LP is for
p
ro
p
ane gas. The LP setting can be further identifi ed by
the large diameter disk on the bottom of the plunger. To
change from one gas to the other sim
p
ly
p
ush the
p
lunge
r
to the side to snap it out of the cap, turn the plunger so
it reads the desired gas type on the bottom, and push
the plunger until it snaps back into place in the cap then
replace the cap into the regulator
.
Never connect an unregulated gas line to the grill.
LP Cylinder Requirements
The LP c
y
linder must be constructed and marked in accor
-
dance with the s
p
ecifi cations for LP gas cylinders of the U.S.
Department of Transportation (DOT) and designed for use
wit
h
a Type 1 system on
l
y.
C
y
linders of free standin
g
g
rills must be secured usin
g
the
provi
d
e
d
cy
l
in
d
er retention system to avoi
d
acci
d
enta
l
movement.
When exchan
g
in
g
y
ou
r
cylinder for a refi ll,
exchange only for a
Type 1 20
lb
cy
l
in
d
er wit
h
an over-fi ll protection
devi
c
e.
Never use a c
y
linder with a dama
g
ed valve.
A dented or rust
y
LP c
y
linder ma
y
be hazardous and should
be avoided. If in doubt, have it checked by your LP su
pp
lier.
Always check for leaks after every LP cylinder change. (See
INDEX: “Leak Test” for further details.)
Always shut off the LP-gas supply at the cylinder when the
grill is not in use.
Cylinders must be stored outdoors in a well-ventilated area
out of the reach of children. If your grill is stored indoors,
the LP c
y
linder must be stored outside.
LP Connections
Make sure the LP cylinder valve is fully closed. It is
p
ossible
for the valve to be o
p
en without releasing gas but, as soon
as
y
ou start connectin
g
the re
g
ulator,
g
as will leak from the
c
onne
c
tion.
LP cylinder with type 1 valve connection
G
A
S
CO
NNE
C
TI
O
N
S
...
co
n
t
in
ued
Do not change the regulator/hose assembly or
use any other assembly than the one supplied
with your grill.
Do not attempt to use a 5LP-A equipped
regulator/hose assembly with a standard 510 POL
cylinder/valve assembly.
Do not store a spare LP-gas cylinder under or
near this appliance.
Never fi ll the cylinder beyond 80 percent full.
If the information above is not followed exactly, a
fi re causing death or serious injury may occur.
WARNING