manual and_installation_instructions

SIDE BURNER ACCESSORY CARE & USE/INSTALLATION

TESTING THE INSTALLATION

Before turning the gas supply on, check for proper installa-

tion using the following test:

1. Plug the transformer back into the receptacle.

2. Push in the gas control knob on your accessory and

watch the igniter. It should glow bright and steady.

3. Turn on the light switch on the grill. Both the grill and

the grill accessory lights should operate together. This

indicates a proper assembly.

Turn the gas on to all appliances.

4. Perform a leak test if you have not done so since

plumbing the unit.

5. Check all burners for proper ignition. Refer to the Light-

ing Instructions for Side Burners.

LEAK TESTING

Leak Test Procedure:

1. Create a soapy solution of 1 part soap and 3 parts

water.

2. Conﬁrm that all control knobs are in the off position.

3. Turn on the fuel supply. For natural gas, turn the valve

handle 1/4 turn to align with the gas ﬂow.

4. For LP, turn the cylinder valve knob counter clockwise

one full rotation.

5. Apply the soap solution generously by paint brush or

squirt bottle on all connections and ﬁttings.

6. If bubbles appear to “grow” on any of the connections,

you have a gas leak. IMMEDIATELY turn off the gas

supply.

FIXING A GAS LEAK

DANGER!

To prevent ﬁre or explosion hazard, DO NOT smoke

or allow any potential source of ignition (sparks,

electrical arcing, etc) in the area while performing a

leak test. Leak tests should be conducted outdoors

only. Never conduct a leak test using ﬁre or ﬂame.

1. Shut off the gas supply

2. Turn all grill controls to the “ON” position to purge the

grill of any gas build-up, then turn the controls back

“OFF”.

3. Wash off the soapy solution with cold water and dry.

4. Tighten the loose joint, or replace the faulty part with

manufacturer-recommended replacement parts.

5. DO NOT attempt to repair the LP cylinder valve if it is

damaged. The only way to safely resolve a damaged

cylinder is to REPLACE IT.

6. Repeat the leak test to ensure that no leaks are present.