Install / Use & Care Manual

Table Of Contents

Door Adjustments

DOOR ALIGNMENT AND ADJUSTMENT

Align and adjust the door if it is not level or not sealing properly. If

the door is not sealed, the unit may not cool properly, or excessive

frost or condensation may form in the interior.

NOTICE

Properly aligned, the door’s gasket should be  rmly in contact

with the cabinet all the way around the door (no gaps). Carefully

examine the door’s gasket to ensure that it is  rmly in contact

with the cabinet. Also make sure the door gasket is not pinched

on the hinge side of the door.

Do not attempt to use the door to raise or pivot your unit. This

would put excessive stress on the hinge system.

Alignment and Adjustment Procedure

1. Open door and remove gasket near the hinges.

2. Using a T-25 Torx bit, loosen each pair of Torx head

screws both the upper and lower hinge plates.

3. Square and align door as necessary.

4. Tighten Torx head screws on hinge.

5. Reinstall gasket into the channel starting at the corner.

REVERSING THE DOOR

1. Open door.

2. Using T-25 Torx bit loosen screw #1 and remove screw #2 on

top and bottom hinge. Slide and remove the door from the

unit.

Note: One hinge includes a metal spacer. Spacer must be used

with that hinge when reversing the door.

3. Remove caps from screw heads on opposite side (2 on top and

2 on bottom). Using #2 Phillips bit, remove the 4 underlying

screws. Reinstall the screws and caps on the opposite side.

4. Partially install screw #1 in the outer most holes on top and

bottom. Rotate door 180o, align hinge over screw #1 and

slide/seat into position. Reinstall screw #2 on top and bottom.

Tighten both screws and install hinge cover.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).

T-25 Torx Screw

CAUTION

Installation