Installation Guide

Hinge Adjustment
It usually is necessary to adjust your hinges once you have
finished the installation of your cabinets (Figure 6). You must do
this before installing any decorative hardware.
Soft Close Hinge Damper
To install, position the damper in the upper corner on the hinge
side of the face frame, pre-drill pilot hole, and fasten with
provided screw. Adjust the damper by twisting the piston left or
right to protrude or retract as necessary (Figure 7).
Drawer Adjustment
DRAWER GLIDES
To remove the drawer from the cabinet, extend the drawer to
the outer most location. Then reach underneath the drawer to
the attaching clips located at the front of the drawer box. Then
squeeze the clips pulling toward the sides which will release the
glides from the drawer box. The drawer will now be ready to be
removed. Lift the drawer away. To reinstall the drawer, make
sure glides are pushed in all the way into the cabinet. Set the
drawer back in the glide tracks and push the drawer all the way
into the cabinet. When the clips attach to the glide you will hear
a click. The glides will align automatically when the drawer is
pushed back in.
Standard Fillers/Decorative Fillers
Decorative Fillers: In contrast to standard fillers, which are
trimmed for a proper fit to complete a cabinet run, decorative
fillers require a 3 in. spacing between cabinets.
STANDARD CABINET INSTALLATION
a) Remove doors and drawers.
b) Using 3/16 in. drill bit, pre-drill holes through face frame,
minimum of 2 holes per side.
a. If you like, you can remove hinge plate(s) and drill holes
so that they will be covered by the hinge plate.
c) Clamp filler in place. To prevent possible wood splitting,
drill pilot hole with 1/8 in. drill bit into filler
d) Secure filler in place with #8 x 2½ in. countersunk screws.
a. Reinstall the hinge plate to cover the countersunk screws.
Toe Kick Installation
Note: Flush-fit end panel(s) should be installed before attaching
the toe kick.
The toe kick should be attached once all of your cabinets have
been installed and secured to the wall. Cut the toe kick to your
exact dimensions. Use small finishing nails to attach the toe
kick to your cabinets. It is recommended that a bead of high
quality caulking material be used to seal the toe kick to the floor
(Figure 9).
Loosen screw for
adjustment of door
left from right
Loosen screw for
adjustment of door
up and down
Figure 6
Side panel
Face frame
Decorative filler
Figure 8
Figure 9
Finishing nail
Toe kick
Figure 7
65°