How to Guide

Figure 2
U180173A
Rev. 09-14
WALL INSTALLATION
Hardware for installation not included.
BATH STORAGE CABINETS / WALL HUTCHES
Depending on the model, matching crown moulding may be
included with the cabinet.
• Options for crown attachment: #6 x 3/4 in. wood screws or
brad nails. To install, simply set the moulding on top of the
cabinet. Make sure the moulding is aligned side to side on
the face frame. Additionally, make sure the front, bottom
edge of the crown moulding lines up with the outer edge of
the door.
• If using wood screws, pre-drill a pilot hole through the crown
into the face frame with a 1/8 in. drill bit then secure the
crown to cabinet (Figure 3).
• To hang cabinet, it will first be necessary to locate the studs in
the wall (in some cases where a stud location will not work, it
will be necessary to choose the appropriate wall hardware).
• After locating the studs, you will need to pre-drill holes through
the back panel.
• Place the cabinet into place, and using a #12 x 3 in. wood
screw, secure the cabinet to the wall through the back panel
(Figure 4).
COUNTER TOP HUTCH
Install the hutch after you have completed installing all of the
base cabinets and the counter top. Set the hutch on top of the
counter top. Fasten the hutch by drilling pilot holes at the stud
location through the back panel. Then fasten the hutch to the
wall with the appropriate wall hardware. For water protection
it is recommended that you caulk the hutch to the counter top
or install a side splash around the bottom edge of the hutch
(Figure 5).
DETERMINE WALL TYPE AND SELECT HARDWARE
• For wall stud installation, insert #12 x 3 in. screws with washers into the
stud locations (not included).
• For drywall installation, drill holes at the appropriate locations and insert
toggle bolts with washers (not included).
• For concrete wall installation, drill 1/4 in. holes at the appropriate locations
and insert #12 wall anchors, followed by #12 x 3 in. screws (not included).
• If you choose to use hanging wire (not included), it must
be capable of supporting 75 lbs. minimum. Attach wire to
brackets as shown below (Figure 2).
• Once the mounting hardware is installed, hang the mirror
from the hardware using the hanging brackets or the hanging
wire (not included).
INSTALLING THE HANGING BRACKETS
• Attach the hanging brackets to the back of the mirror using
the included screws (Figure 1).
Mirrors
Figure 5
Backsplash
WALL
Counter top
VISTA SUPERIOR
TOP VIEW
Use tornillos de ¾ pulg
(no se incluyen)
Marco frontal
Face frame
Use 3/4" screw
(not included)
Figure 3
Suggested
hole
locations
Ubicaciones
de los
orificios
sugeridas
Figure 4
Figure 1