User manual

3.5 DISPLAY / CARDS – telephone line card programming

After DISPLAY button push (DISPLAY LED is steady) and choosing telephone line card

(CARDS 1 – 8) it is possible to enter the chosen telephone line card settings menu with

F2 (SETUP) button.

CONSOLE VER: CPM2.60.BC06

CARD 1 OPTIONS

HSK LENGTH 120

CALLER ID ENABLE

+ – PAGE CANCEL

F1 F2 F3 F4

It is recommended to modify the following settings only (if it is necessary):

• HSK LENGTH

Here you can change the Handshake and Kissoff length of line card.

• CALLER ID

ENABLE – The telephone numbers of the call to the given line card appears on LCD

display of ENIGMA II unit (if telephone number sending is enabled at service provider

and 'Caller ID Message' is enabled in Enigma II unit).

DISABLE – Telephone numbers from the given line card are not shown on ENIGMA II.

Note: Function might be useful for debugging during communicator connecting to

monitoring station, as the phone number is displayed in case of bad communication

format too.

Note: Before changing HSK SEQUENCE / TIMING always consult with your distributor.

Note: After choosing the telephone line card (CARDS 1 – 8), with F3 (STATUS) button

you can check the firmware version of the line card (for example: LC-2.20.BA14).