Instructions

Lens
Lens
IR LEDS
IR LEDS
Wired Network
Status Light
Wired Network
Status Light
Light Sensor
Light Sensor
Speaker
Speaker
Microphone
Microphone
Wi-Fi Network
Status Light
Wi-Fi Network
Status Light
Micro SD
Card Slot
Micro SD Card Slot
FN Button
FN Button
Reset
Infrared light adjustment.
Audio from the APP side.
Additional light in low-light conditions.
To connect Ethernet and Power.
Transfer the voice to vimtag APP.
Green light flashes shows positive connectivity.
Reserved function key.
Green light flashes 3 times shows successful
Wi-Fi connection.
Support Micro SD Card Storage ( up to 64G).
RESET key is located on the bottom of camera.
Long-press button when device is running normal.
The device will restore factory settings.
Capture videos.
Product Diagram
Adapter
Reset
Adapter
Rest
FN
Smart Cloud Camera
M1 Series
Quick installation Guide
Thank you for using Vimtag Smart Cloud Camera,
Please follow these steps.
Description Introduction Description Introduction
Install ‘vimtag’ App
A. Scan the barcode OR download the "Vimtag" APP and install it. Register
your account and finish your Wi-Fi connection according to the procedures.
Mobile Phone App
B. You can also download the 'Vimtag' on APP store (iOS) & Play store (Android).
Connect Camera
After connecting power, downloading the 'Vimtag' APP and registering your
account on your phone, please login APP and enter 'Device List' interface.
Click '+' at the left top of the interface, a QR Code scanning interface will
appear. Scan the QR code at the bottom of the camera or enter ID account
manually and then choose WiFi or Ethernet connection.
Power
Router
Phone
Router
Power
Click the Ethernet connection icon and connect Ethernet cable. After 50
seconds, if the wired network indicator will flash green 3 times every
3 seconds, that means connect successfully.
Method 1: Ethernet connection
Click the Wi-Fi icon, input Wi-Fi name and password, and then click 'Next Step'.
Wait a few seconds, Wi-Fi connection will be successful.
Ps: Cellphone must connect the Wi-Fi signal at this situation, because camera
will connect the Wi-Fi signal via cellophane.
Method 2: Wi-Fi connection
ID
Re st
FN
Res t
FN