Specifications

Vincent

BASIC FUNCTIONS AND SETTINGS

OPERATING THE APPLIANCE

Operation Button(s) Description

Switch on and off

POWER (3)

The amplifier is switched on and off using this button at the front panel, there is

no standby option. When switched off the device is internally separated from

the AC power. As a precaution, before switching on, the volume setting of your

system’s amplifier and the headphone volume (12) should be reduced.

Change the level of the

analogue audio outputs

(13) at the rear panel

VOL+ (33)

VOL- (34)

This function may only be activated with the remote control and only during

playback. This control is to allow the adaptation of the player to the system

(mainly the amplifier) and it must not be used to change the volume of the CD

player in daily use. It is sufficient for almost all amplifiers/receivers/preamplifiers

to put the setting to the maximum and to leave it there. A different value is only

used if the CD player is much louder compared with the other sources at the

amplifier/receiver or it is distorted (clipping). Hold down the “VOL+” button to

raise the output level. Use the “VOL-” to reduce it. The two-figure value of the

volume appears in the display. The maximum signal level is reached with a set-

ting of 26 and the minimum is at 00. This volume control has no effect on the

volume of the headphones (11) connected to the CD player. It changes the out-

put level of all analogue outputs to the same extent.

Volume of the connec-

ted headphones (11)

LEVEL (12)

This function can only be operated on the front of the device. Turn the dial

“LEVEL” clockwise to increase the volume in the headphones and anticlockwise

to reduce the volume. This volume control has no effect on the output level of the

analogue “AUDIO OUTPUTS” (13) on the back of the device.

Change the brightness

of the front panel

display

DIMMER (17)

This function can only be operated using the associated remote control button.

When repeatedly pressed, the display (2) brightness is periodically reduced

(1x), switched off (2x) and restored to the original, maximum brightness (3x).